|
W83977F Datasheet, PDF (14/181 Pages) Winbond – PLUG & PLAY 1.0A COMPLIANT | |||
|
◁ |
W83977F/ W83977AF
PRELIMINARY
Infrared
⢠Support IrDA version 1.0 SIR protocol with maximum baud rate up to 115.2K bps
⢠Support SHARP ASK-IR protocol with maximum baud rate up to 57,600 bps
⢠Support IrDA version 1.1 MIR (1.152M bps) and FIR (4M bps) protocol [W83977AF only]
--- Single DMA channel for transmitter or receiver
--- 3rd UART with 32-byte FIFO is supported in both TX/RX transmission [W83977AF only]
--- 8-byte status FIFO is supported to store received frame status (such as overrun CRC error, etc.)
⢠Support auto-config SIR and FIR [W83977AF only]
Parallel Port
⢠Compatible with IBM parallel port
⢠Support PS/2 compatible bi-directional parallel port
⢠Support Enhanced Parallel Port (EPP) â Compatible with IEEE 1284 specification
⢠Support Extended Capabilities Port (ECP) â Compatible with IEEE 1284 specification
⢠Extension FDD mode supports disk drive B; and Extension 2FDD mode supports disk drives A and
B through parallel port
⢠Enhanced printer port back-drive current protection
Advanced Power Management (APM) Controlling
⢠Power turned on when RTC reaches a preset date and time
⢠Power turned on when a ring pulse or pulse train is detected on the PHRI, or when a high to low
transition on PWAKIN1, or PWAKIN2 input signals
⢠Power turned on when PANSW input signal indicates a switch on event
⢠Power turned off when PANSW input signal indicates a switch off event
⢠Power turned off when a fail-safe event occurs (power-save mode detected but system is hung up)
⢠Power turned off when software issues a power off command
Keyboard Controller
⢠8042 based with optional F/W from AMIKKEYTM-2, Phoenix MultiKey/42TM or customer code
with 2K bytes of programmable ROM, and 256 bytes of RAM
⢠Asynchronous Access to Two Data Registers and One status Register
⢠Software compatibility with the 8042 and PC87911 microcontrollers
⢠Support PS/2 mouse
⢠Support port 92
⢠Support both interrupt and polling modes
⢠Fast Gate A20 and Hardware Keyboard Reset
⢠8 Bit Timer/ Counter; support binary and BCD arithmetic
⢠6, 8, 12, or 16 Mhz operating frequency (16 Mhz available only if input clock rate = 14.318 Mhz)
Publication Release Date: March 1998
-3 -
Revision 0.58
|
▷ |