W83977F Datasheet, PDF (130/181 Pages) Winbond – PLUG & PLAY 1.0A COMPLIANT

W83977F/ W83977AF
Bit 3 : PRTPWD
= 0 Power down
= 1 No Power down
Bit 2 : IRPWD
= 0 Power down
= 1 No Power down
Bit 1 : Reserved.
Bit 0 : FDCPWD
= 0 Power down
= 1 No Power down
PRELIMINARY
CR23 (Default 0x00)
Bit7-6 : Reserved
Bit 5-3 : APDTMS2 APDTMS1 APDTMS0
= 000 4 seconds count-down time of the APD mode.
= 001 8 seconds count-down time of the APD mode.
= 010 16 seconds count-down time of the APD mode.
= 011 32 seconds count-down time of the APD mode.
= 100 1 minute count-down time of the APD mode.
= 101 2 minutes count-down time of the APD mode.
= 110 4 minutes count-down time of the APD mode.
= 111 16 minutes count-down time of the APD mode.
Bit 2-0 : OSCS2, OSCS1, OSCS0.
= 000 Default power-on state after power on reset.
= 1xx Stop Clock supply to whole chip, but PLL circuit still in operation.
= 001 Stop Clock supply to whole chip and PLL circuit.
= 010 Standby for automatic power-down(APD).
= 011 Automatic power-down(APD) has been happened.
CR24 (Default 0b1ss00sss)
Bit 7 : EN16SA
= 0 12 bit Address Qualification
= 1 16 bit Address Qualification
Bit 6-5 : CLKSEL, ENPLL
= 00 The clock input on Pin 1 should be 14.31818 Mhz.
= 01 The clock input on Pin 1 should be 24 Mhz.
= 11 The clock input on Pin 1 should be 48 Mhz.
Bit 4 : RWPNPREG
= 0 Disable read/write PnP mode config registers by using the method of non-PnP mode
= 1 Enable read/write PnP mode config registers by using the method of non-PnP mode
Bit 3 : Reserved
- 118 -
Publication Release Date: March 1998
Revision 0.58