CC2510F16 Datasheet, PDF (97/244 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory, 2.4 GHz RF Transceiver, and USB Controller

CC2510Fx / CC2511Fx
PICTL (0x8C) - Port Interrupt Control
Bit Field Name Reset R/W Description
7
-
R0 Not used
6
0
R/W Not Used
5
P2IEN
0
R/W Port 2, inputs 4 to 0 interrupt enable.
0 Interrupts are disabled
1 Interrupts are enabled
4
P0IENH
0
R/W Port 0, inputs 7 to 4 interrupt enable.
0 Interrupts are disabled
1 Interrupts are enabled
3
P0IENL
0
R/W Port 0, inputs 3 to 0 interrupt enable.
0 Interrupts are disabled
1 Interrupts are enabled
2
P2ICON
0
R/W Port 2, inputs 4 to 0 interrupt configuration. This bit selects the interrupt request
condition for all port 2 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
1
P1ICON
0
R/W Port 1, inputs 7 to 0 interrupt configuration. This bit selects the interrupt request
condition for all port 1 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
0
P0ICON
0
R/W Port 0, inputs 7 to 0 interrupt configuration. This bit selects the interrupt request
condition for all port 0 inputs. For CC2511Fx, this bit must be set to 0 when USB is
used, since the internal USB resume interrupt mapped to P0[7] uses rising edge.
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
P1IEN (0x8D) - Port 1 Interrupt Mask
Bit Field Name Reset R/W Description
7:0 P1_[7:0]IEN 0x00 R/W Port P1_7 to P1_0 interrupt enable
0 Interrupts are disabled
1 Interrupts are enabled
SWRS055F
Page 97 of 241