CC2510F16 Datasheet, PDF (9/244 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory, 2.4 GHz RF Transceiver, and USB Controller

CC2510Fx / CC2511Fx
4 Operating Conditions
4.1 CC2510Fx Operating Conditions
The operating conditions for CC2510Fx are listed in Table 3 below.
Parameter
Min
Max
Operating ambient temperature, T_A −40
85
Operating supply voltage (VDD)
2.0
3.6
Unit Condition
°C
V All supply pins must have the same voltage
Table 3: Operating Conditions for CC2510Fx
4.2 CC2511Fx Operating Conditions
The operating conditions for CC2511Fx are listed in Table 4 below.
Parameter
Min
Max
Operating ambient temperature, T_A 0
85
Operating supply voltage (VDD)
3.0
3.6
Unit Condition
°C
V All supply pins must have the same voltage
Table 4: Operating Conditions for CC2511Fx
5 General Characteristics
T_A = 25°C, VDD = 3.0 V if nothing else stated
Parameter
Min
Typ
Max
Unit
Condition/Note
Radio part
Frequency range 2400
2483.5
MHz
There will be spurious signals at n/2·crystal oscillator
frequency (n is an integer number). RF frequencies at
n/2·crystal oscillator frequency should therefore be
avoided (e.g. 2405, 2418, 2431, 2444, 2457, 2470 and
2483 MHz when using a 26 MHz crystal).
Data rate
1.2
500
kBaud 2-FSK
1.2
250
kBaud GFSK
26
500
kBaud (Shaped) MSK (also known as differential offset QPSK)
Optional Manchester encoding (the data rate in kbps will
be half the baud rate)
Wake-Up Timing
PM1 Æ Active
4
Mode
µs
Digital regulator on. HS RCOSC and high speed crystal
oscillator off. 32.768 kHz XOSC or low power RCOSC
running.
PM2/3Æ Active
100
Mode
SLEEP.OSC_PD=1 and CLKCON.OSC=1
µs
Digital regulator off. HS RCOSC and high speed crystal
oscillator off. 32.768 kHz XOSC or low power RCOSC
running (PM2). No crystal oscillators or RC oscillators
are running in PM3.
SLEEP.OSC_PD=1 and CLKCON.OSC=1
Table 5: General Characteristics
SWRS055F
Page 9 of 241