CC2510F16 Datasheet, PDF (11/244 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory, 2.4 GHz RF Transceiver, and USB Controller

CC2510Fx / CC2511Fx
Parameter
Active mode with
radio in TX
PM0
PM1
PM2
PM3
Peripheral
Current
Consumption
Timer 1
Timer 2
Timer 3
Timer 4
ADC
Min Typ Max
19.4
15.7
16.9
26
18.5
15.5
26
4.3
220
0.5
1
0.3
1
Unit Condition
mA 10 kBaud, input at sensitivity limit, system clock running at 26 MHz.
mA 10 kBaud, input at sensitivity limit, system clock running at 203 kHz.
mA 10 kBaud, input well above sensitivity limit, system clock running at
26 MHz.
System clock running at 26 MHz.
Digital regulator on. High speed crystal oscillator and low power
RCOSC running. Radio in TX mode
mA 0 dBm output power (PA_TABLE0=0xFE). See Table 7 for typical
variation over operating conditions
mA −6 dBm output power (PA_TABLE0=0x7F)
mA −12 dBm output power (PA_TABLE0=0x95)
mA System clock running at 24 MHz.
Digital regulator on. High speed crystal oscillator and low power
RCOSC running. Radio in TX mode ^w/0 dBm output power
(PA_TABLE0=0xFE)
mA Same as active mode, but the CPU is not running (see 12.1.2.2 for
details). System clock running at 26 MHz
µA Digital regulator on. HS RCOSC and high speed crystal oscillator off.
32.768 kHz XOSC or low power RCOSC running (see 12.1.2.3 for
details)
µA Digital regulator off. HS RCOSC and high speed crystal oscillator off.
Low power RCOSC running (see 12.1.2.4 for details)
µA Digital regulator off. No crystal oscillators or RC oscillators are
running (see 12.1.2.5 for details)
Add to the figures above if the peripheral unit is activated
2.7
µA/MHz When running
1.3
µA/MHz When running
1.6
µA/MHz When running
2
µA/MHz When running
1.2
mA During conversion
Table 6: Current Consumption
SWRS055F
Page 11 of 241