TLK110 Datasheet, PDF (40/104 Pages) Texas Instruments – Industrial Temp, Single Port 10/100Mbs Ethernet Physical Layer

TLK110
SLLS901A – DECEMBER 2011 – REVISED FEBRUARY 2012
7 Design Guidelines
www.ti.com
7.1 TPI Network Circuit
Figure 7-1 shows the recommended circuit for a 10/100Mbs twisted pair interface. Below is a partial list of
recommended transformers. It is important that the user realize that variations with PCB and component
characteristics require that the application be tested to verify that the circuit meets the requirements of the
intended application.
• Pulse H1102
• Pulse HX1188
RD–
49.9 W
49.9 W
Vdd
Vdd
0.1 mF
Common-mode chokes
may be required.
1:1
RD–
RD+
0.1 mF*
RD+
TD–
49.9 W
49.9 W
TD+
Vdd
0.1 mF
TD–
0.1 mF*
1:1 ^T1
TD+
RJ45
Note: Center tap is connected to Vdd
* Place capacitors close to the
transformer center taps
Place resistors and capacitors close to the device.
All values are typical and are ±1%
S0339-01
Figure 7-1. 10/100Mbs Twisted Pair Interface
7.2 Clock In (XI) Requirements
The TLK110 supports an external CMOS-level oscillator source or an internal oscillator with an external
crystal.
7.2.1 Oscillator
If an external clock source is used, XI should be tied to the clock source and XO should be left floating.
The amplitude of the oscillator should be a nominal voltage of 3.3V.
40
Design Guidelines
Submit Documentation Feedback
Product Folder Link(s): TLK110
Copyright © 2011–2012, Texas Instruments Incorporated