LM3S6G11 Datasheet, PDF (351/827 Pages) Texas Instruments – Stellaris® LM3S6G11 Microcontroller

OBSOLETE: TI has discontinued production of this device.
Stellaris^® LM3S6G11 Microcontroller
8.3.4.3
8.3.4.4
2. Program the primary destination end pointer at offset 0x084 to the address of ping-pong buffer
A + 0x3F.
3. Program the alternate source end pointer at offset 0x280 to the address of the peripheral's
receive buffer.
4. Program the alternate destination end pointer at offset 0x284 to the address of ping-pong buffer
B + 0x3F.
The primary control word at offset 0x088 and the alternate control word at offset 0x288 are initially
programmed the same way.
1. Program the primary channel control word at offset 0x088 according to Table 8-12.
2. Program the alternate channel control word at offset 0x288 according to Table 8-12.
Table 8-12. Channel Control Word Configuration for Peripheral Ping-Pong Receive Example
Field in DMACHCTL
DSTINC
DSTSIZE
SRCINC
SRCSIZE
reserved
ARBSIZE
XFERSIZE
NXTUSEBURST
XFERMODE
Bits
31:30
29:28
27:26
25:24
23:18
17:14
13:4
3
2:0
Value
0
0
3
0
0
3
63
0
3
Description
8-bit destination address increment
8-bit destination data size
Source address does not increment
8-bit source data size
Reserved
Arbitrates after 8 transfers
Transfer 64 items
N/A for this transfer type
Use Ping-Pong transfer mode
Note:
In this example, it is not important if the peripheral makes a single request or a burst request.
Because the peripheral has a FIFO that triggers at a level of 8, the arbitration size is set to
8. If the peripheral does make a burst request, then 8 bytes are transferred, which is what
the FIFO can accommodate. If the peripheral makes a single request (if there is any data
in the FIFO), then one byte is transferred at a time. If it is important to the application that
transfers only be made in bursts, then the Channel Useburst SET[8] bit should be set in
the DMA Channel Useburst Set (DMAUSEBURSTSET) register.
Configure the Peripheral Interrupt
An interrupt handler should be configured when using μDMA Ping-Pong mode, it is best to use an
interrupt handler. However, the Ping-Pong mode can be configured without interrupts by polling.
The interrupt handler is triggered after each buffer is complete.
1. Configure and enable an interrupt handler for the peripheral.
Enable the μDMA Channel
Now the channel is configured and is ready to start.
1. Enable the channel by setting bit 8 of the DMA Channel Enable Set (DMAENASET) register.
July 24, 2012
351
Texas Instruments-Production Data