LM3S6611 Datasheet, PDF (24/647 Pages) List of Unclassifed Manufacturers – Microcontroller

Revision History
Table 1. Revision History (continued)
Date
June 2010
Revision Description
7393 ■ Corrected base address for SRAM in architectural overview chapter.
■ Clarified system clock operation, adding content to “Clock Control” on page 171.
■ In Signal Tables chapter, added table "Connections for Unused Signals."
■ In "Thermal Characteristics" table, corrected thermal resistance value from 34 to 32.
■ In "Reset Characteristics" table, corrected value for supply voltage (VDD) rise time.
■ Additional minor data sheet clarifications and corrections.
April 2010
7007
■ Added caution note to the I²C Master Timer Period (I2CMTPR) register description and changed
field width to 7 bits.
■ Removed erroneous text about restoring the Flash Protection registers.
■ Added note about RST signal routing.
■ Clarified the function of the TnSTALL bit in the GPTMCTL register.
■ Corrected XTALNPHY pin description.
■ Additional minor data sheet clarifications and corrections.
January 2010
6712
■ In "System Control" section, clarified Debug Access Port operation after Sleep modes.
■ Clarified wording on Flash memory access errors.
■ Added section on Flash interrupts.
■ Clarified operation of SSI transmit FIFO.
■ Made these changes to the Operating Characteristics chapter:
– Added storage temperature ratings to "Temperature Characteristics" table
– Added "ESD Absolute Maximum Ratings" table
■ Made these changes to the Electrical Characteristics chapter:
– In "Flash Memory Characteristics" table, corrected Mass erase time
– Added sleep and deep-sleep wake-up times ("Sleep Modes AC Characteristics" table)
– In "Reset Characteristics" table, corrected units for supply voltage (VDD) rise time
October 2009
6462
■ Removed erroneous reference to the WRC bit in the Hibernation chapter.
■ Deleted reset value for 16-bit mode from GPTMTAILR, GPTMTAMATCHR, and GPTMTAR registers
because the module resets in 32-bit mode.
■ Made these changes to the Electrical Characteristics chapter:
– Removed V_SIH and V_SIL parameters from Operating Conditions table.
– Added table showing actual PLL frequency depending on input crystal.
– Changed the name of the t_{HIB_REG_WRITE} parameter to t_{HIB_REG_ACCESS}.
– Changed SSI set up and hold times to be expressed in system clocks, not ns.
July 2009
5920 Corrected ordering numbers.
24
July 16, 2014
Texas Instruments-Production Data