LM3S6611 Datasheet, PDF (22/647 Pages) List of Unclassifed Manufacturers – Microcontroller

Revision History
Revision History
The revision history table notes changes made between the indicated revisions of the LM3S6611
data sheet.
Table 1. Revision History
Date
July 2014
Revision Description
15852.2743 ■ In JTAG chapter, clarified JTAG-to-SWD Switching and SWD-to-JTAG Switching.
■ In System Control chapter, clarified behavior of Reset Cause (RESC) register external reset bit.
■ In Internal Memory chapter:
– Added sections on Execute-Only Protection, Read-Only Protection, and Permanently Disabling
Debug.
– Noted that the Boot Configuration (BOOTCFG) register requires a POR before committed
changes to the Flash-resident registers take effect.
■ In UART chapter:
– Clarified that the transmit interrupt is based on a transition through level.
– Corrected reset for UART Raw Interrupt Status (UARTRIS) register.
■ In Electrical Characteristics chapter, updated Crystal Characteristics and Ethernet Reference Crystal
tables.
■ In Ordering and Contact Information appendix, moved orderable part numbers table to addendum.
■ Additional minor data sheet clarifications and corrections.
June 2012
12746.2515 ■ Removed extended temperature package.
■ Minor data sheet clarifications and corrections.
November 2011
11108
■ Added module-specific pin tables to each chapter in the new Signal Description sections.
■ In Hibernation chapter:
– Changed terminology from non-volatile memory to battery-backed memory.
– Clarified Hibernation module register reset conditions.
■ In Timer chapter, clarified that in 16-Bit Input Edge Time Mode, the timer is capable of capturing
three types of events: rising edge, falling edge, or both.
■ In UART chapter, clarified interrupt behavior.
■ In SSI chapter, corrected SSIClk in the figure "Synchronous Serial Frame Format (Single Transfer)".
■ In Signal Tables chapter:
– Corrected pin numbers in table "Connections for Unused Signals" (other pin tables were correct).
■ In Electrical Characteristics chapter:
– Added parameter "Input voltage for a GPIO configured as an analog input" to the "Maximum
Ratings" table.
– Corrected Nom values for parameters "TCK clock Low time" and "TCK clock High time" in "JTAG
Characteristics" table.
■ Additional minor data sheet clarifications and corrections.
22
July 16, 2014
Texas Instruments-Production Data