GC5018 Datasheet, PDF (110/115 Pages) Texas Instruments – 8-CHANNEL WIDEBAND RECEIVER

GC5018
8-CHANNEL WIDEBAND RECEIVER
SLWS169 – MAY 2005
www.ti.com
5.5 Power and Ground Signals
Signal Name
VDDS
VDDS_VFUSE
DVDD
DVSS
Ball
A6,
D5, D6, D10, D13, D14,
E5, E13, E14,
F1, F5, F14, F18,
J4, J15,
K15,
L5,
M5,
N5, N14,
P5, P13, P14,
R5, R6, R7, R8, R12, R13, R14,
V6
T16
A13,
D7, D12,
E6, E7, E8, E10, E11, E12,
G5, G14,
H5, H14,
J5, J14,
L14,
M14,
N1, N18,
P6, P7, P8, P10, P11, P12,
V13
A8, A11,
E9,
F6, F7, F8, F9, F10, F11, F12, F13,
G6, G7, G8, G9, G10, G11, G12, G13,
H1, H6, H7, H12, H13, H18
J6, J7, J12, J13,
K5, K6, K7, K12, K13, K14,
L1, L6, L7, L12, L13, L18,
M6, M7, M8, M9, M10, M11, M12, M13,
N6, N7, N8, N9, N10, N11, N12, N13,
P9,
V8, V11
Description
Digital I/O Power (3.3 V), also called Vpad
Digital I/O Power (3.3 V)
Digital Core Power (1.5 V), also called Vcore
Digital Ground
5.6 Digital Supply Monitoring
Signal Name
dvddmon
dvssmon
Ball Description
T10 It is recommended that this pin be brought to a probe point for monitoring and debugging purposes.
R11 It is recommended that this pin be brought to a probe point for monitoring and debugging purposes.
5.7 JTAG
The JTAG standard for boundary scan testing will be implemented for board testing purposes. Internal
scan test will not be supported. Five device pins are dedicated for JTAG support: tdi, tdo, tms, tck, and
trst_n. The JTAG bsdl configuration file will be available from TI at a later time.
NOTE
The trst_n pin should be asserted after power up to insure the JTAG logic is properly
initialized.
110 GC5018 PINS