C8051F99X_10 Datasheet, PDF (93/322 Pages) Silicon Laboratories – Ultra Low Power, 8-2 kB Flash, Capacitive Sensing MCU

C8051F99x-C8051F98x
CP0+
VIN+
VIN- ^CP0-
+
CP0
_
OUT
CIRCUIT CONFIGURATION
Positive Hysteresis Voltage
(Programmed with CP0HYP Bits)
VIN-
INPUTS
VIN+
Negative Hysteresis Voltage
(Programmed by CP0HYN Bits)
VOH
OUTPUT
VOL
Negative Hysteresis
Disabled
Maximum
Negative Hysteresis
Positive Hysteresis
Disabled
Maximum
Positive Hysteresis
Figure 7.2. Comparator Hysteresis Plot
7.5. Comparator Register Descriptions
The SFRs used to enable and configure the comparator are described in the following register
descriptions. The comparator must be enabled by setting the CP0EN bit to logic 1 before it can be used.
From an enabled state, a comparator can be disabled and placed in a low power state by clearing the
CP0EN bit to logic 0.
Important Note About Comparator Settings: False rising and falling edges can be detected by the
Comparator while powering on or if changes are made to the hysteresis or response time control bits.
Therefore, it is recommended that the rising-edge and falling-edge flags be explicitly cleared to logic 0 a
short time after the comparator is enabled or its mode bits have been changed. The Comparator Power Up
Time is specified in Section “Table 4.14. Comparator Electrical Characteristics” on page 61.
Rev. 1.0
93