CLRC663 Datasheet, PDF (68/132 Pages) NXP Semiconductors – Contactless reader IC

NXP Semiconductors
CLRC663
Contactless reader IC
Table 62. IRQ1 bits
Bit
Symbol Description
7
Set
1: writing a 1 to a bit position 5..0 sets the interrupt request
0: Writing a 1 to a bit position 5..0 clears the interrupt request
6
GlobalIrq Set, if an enabled Irq occurs.
5
LPCD_Irq Set if a card is detected in Low-power card detection sequence.
4
Timer4Irq Set to logic 1 when Timer4 has an underflow.
3
Timer3Irq Set to logic 1 when Timer3 has an underflow.
2
Timer2Irq Set to logic 1 when Timer2 has an underflow.
1
Timer1Irq Set to logic 1 when Timer1 has an underflow.
0
Timer0Irq Set to logic 1 when Timer0 has an underflow.
9.5.3 IRQ0En register
Interrupt request enable register for IRQ0. This register allows to define if an interrupt
request is processed by the CLRC663.
Table 63. IRQ0En register (address 08h)
Bit
7
6
5
Symbol Irq_Inv Hi AlertIrqEn LoAlertIrqEn
Access
r/w
r/w
r/w
rights
4
IdleIrqEn
r/w
3
TxIrqEn
r/w
2
RxIrqEn
r/w
1
ErrIrqEn
r/w
0
RxSOFIrqEn
r/w
Table 64. IRQ0En bits
Bit Symbol
Description
7
Irq_Inv
Set to one the signal of the IRQ pin is inverted
6
Hi AlerIrqEn Set to logic 1, it allows the High Alert interrupt Request (indicated by the
bit HiAlertIrq) to be propagated to the GlobalIrq
5
Lo AlertIrqEn Set to logic 1, it allows the Low Altert Interrupt Request (indicated by the
bit LoAlertIrq) to be propagated to the GlobalIrq
4
IdleIrqEn
Set to logic 1, it allows the Idle interrupt request (indicated by the bit
IdleIrq) to be propagated to the GlobalIrq
3
TxIRqEn
Set to logic 1, it allows the transmitter interrupt request (indicated by the
bit TxtIrq) to be propagated to the GlobalIrq
2
RxIRqEn
Set to logic 1, it allows the receiver interrupt request (indicated by the bit
RxIrq) to be propagated to the GlobalIrq
1
ErrIRqEn
Set to logic 1, it allows the Error interrupt request (indicated by the bit
ErrorIrq) to be propagated to the GlobalIrq
0
RxSOFIrqEn Set to logic 1, it allows the RxSOF interrupt request (indicated by the bit
RxSOFIrq) to be propagated to the GlobalIrq
9.5.4 IRQ1En
Interrupt request enable register for IRQ1.
CLRC663
Product data sheet
COMPANY PUBLIC
All information provided in this document is subject to legal disclaimers.
Rev. 3.3 — 3 April 2012
171133
© NXP B.V. 2012. All rights reserved.
68 of 132