CLRC663 Datasheet, PDF(2/132 Page) NXP Semiconductors

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

CLRC663 Datasheet, PDF (2/132 Pages) NXP Semiconductors – Contactless reader IC

◁

NXP Semiconductors

CLRC663

Contactless reader IC

The CLRC663 is supporting the P2P passive initiator mode in accordance with

ISO/IEC 18092.

The CLRC663 supports the vicinity protocol according to ISO/IEC15693, EPC UID and

ISO/IEC 18000-3 mode 3/ EPC Class-1 HF.

The following host interfaces are supported:

â¢ Serial Peripheral Interface (SPI)

â¢ Serial UART (similar to RS232 with voltage levels dependent on pin voltage supply)

â¢ I2C-bus interface (two versions are implemented: I2C and I2CL)

The CLRC663 supports the connection of a secure access module (SAM). A dedicated

separate I2C interface is implemented for a connection of the SAM. The SAM can be used

for high secure key storage and acts as a very performant crypto coprocessor. A

dedicated SAM is available for connection to the CLRC663.

3. Features and benefits

ï® High RF output power frontend IC for transfer speed up to 848 kbit/s

ï® Supports ISO/IEC 14443 A/MIFARE, ISO/IEC 14443 B and FeliCa

ï® P2P passive initiator mode in accordance with ISO/IEC 18092

ï® Supports ISO/IEC15693, ICODE EPC UID and ISO/IEC 18000-3 mode 3/ EPC

Class-1 HF

ï® Supports MIFARE Classic encryption in read/write mode

ï® Low-Power Card Detection

ï® Compliance to âEMV contactless protocol specification V2.0.1â on RF level can be

achieved

ï® Antenna connection with minimum number of external components

ï® Supported host interfaces:

ïµ SPI up to 10 Mbit/s

ïµ I2C-bus interfaces up to 400 kBd in Fast mode, up to 1000 kBd in Fast mode plus

ïµ RS232 Serial UART up to 1228.8 kBd, with voltage levels dependent on pin

voltage supply

ï® Separate I2C-bus interface for connection of a secure access module (SAM)

ï® FIFO buffer with size of 512 byte for highest transaction performance

ï® Flexible and efficient power saving modes including hard power down, standby and

low-power card detection

ï® Cost saving by integrated PLL to derive system CPU clock from 27.12 MHz RF quartz

crystal

ï® 3.3 V to 5 V power supply

ï® Up to 8 free programmable input/output pins

ï® Typical operating distance in read/write mode for communication to a

ISO/IEC 14443A/MIFARE Card up to 12 cm, depending on the antenna size and

tuning

CLRC663

Product data sheet

COMPANY PUBLIC

All information provided in this document is subject to legal disclaimers.

Rev. 3.3 â 3 April 2012

171133

2 of 132

▷