CLRC663 Datasheet, PDF (53/132 Pages) NXP Semiconductors – Contactless reader IC

NXP Semiconductors
CLRC663
Contactless reader IC
To leave the modem off mode clears the ModemOff bit in the register Control.
8.9.3 Low-Power Card Detection (LPCD)
The low-power card detection is an energy saving modus when the CLRC663 is not fully
powered permanently.
The LPCD works in two phases. First the standby phase is controlled by the wake-up
counter (WUC), which defines the duration of the standby of the CLRC663. Second phase
is the detection-phase. In this phase the values of the I and Q channel are detected and
stored in the register map. (LPCD_I_Result, LPCD_Q_Result).This time period can be
handled with Timer3. The value is compared with the min/max values in the registers
(LPCD_IMin, LPCD_IMax; LPCD_QMin, LPCD_QMax). If it exceeds the limits, a LPCDIrq
is raised.
After the command LPCD the standby of the CLRC663 is activated, if selected. The
wake-up Timer4 can activate the system after a given time. For the LPCD it is
recommended to set T4AutoWakeUp and T4AutoRestart, to start the timer and then go to
standby. If a card is detected the timer stops and the communication can be started. If
T4AutoWakeUp is not set, the IC will not enter Standby mode in case no card is detected.
8.9.4 Reset and start-up time
A 10 s constant high level at the PDOWN pin starts the internal reset procedure.
The following figure shows the internal voltage regulator:
PVDD
PDown
GLITCH
FILTER
V_SS
V_DD
1.8 V
INTERNAL VOLTAGE
REGULATOR
1.8 V
AVDD
DVDD
V_SS
001aan360
Fig 33. Internal PDown to voltage regulator logic
This internal procedure consists of two phases:
• Power on reset
• Startup time
When the CLRC663 has finished this two phases the reader IC is in Full mode and is
ready to be used. Refer to Section 13.1 “Timing characteristics”
CLRC663
Product data sheet
COMPANY PUBLIC
All information provided in this document is subject to legal disclaimers.
Rev. 3.3 — 3 April 2012
171133
© NXP B.V. 2012. All rights reserved.
53 of 132