|
PIC16F753 Datasheet, PDF (195/238 Pages) Microchip Technology – 14/16-Pin, Flash-Based 8-Bit CMOS Microcontrollers | |||
|
◁ |
PIC16F753/HV753
22.7 DC Characteristics: PIC16HV753-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ï£ TA ï£ +125°C for extended
Param.
No.
Device Characteristics
Min.
Typâ
Max.
Units
VDD
Conditions
Note
D020E Power-down Base
Current (IPD)(2,3)
PIC16HV753
D021E
â 135 TBD ïA
â 210 TBD ïA
â 260 TBD ïA
â 135 TBD ïA
2.0 WDT, BOR, Comparator, DAC and
3.0 FVR disabled
4.5
2.0 WDT Current(1)
D022E
D023E
D024E
â 210 TBD ïA
â 265 TBD ïA
â 215 TBD ïA
â 265 TBD ïA
â 185 TBD ïA
â 265 TBD ïA
â 320 TBD ïA
â
90 TBD ïA
â 107 TBD ïA
3.0
4.5
3.0 BOR Current(1)
4.5
2.0 CxSP = 1, Comparator Current(1),
3.0 single comparator enabled
4.5
2.0 CxSP = 0, Comparator Current(1),
3.0 single comparator enabled
D025E
D026E
â 127 TBD ïA
â 210 TBD ïA
â 260 TBD ïA
â 215 TBD ïA
4.5
3.0 A/D Current(1), no conversion in
4.5 progress
3.0 DAC Current(1)
D027E
â 265 TBD ïA
â 485 TBD ïA
â 615 TBD ïA
4.5
3.0 FVR Current(1), FVRBUFEN = 1,
4.5 REFOUT buffer enabled
Legend: TBD = To Be Determined
* These parameters are characterized but not tested.
â Data in âTypâ column is at 4.5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral ï current can be determined by subtracting the base IDD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
3: Shunt regulator is always on and always draws operating current.
ï£ 2013 Microchip Technology Inc.
Preliminary
D40001709A-page 195
|
▷ |