PIC16F753 Datasheet, PDF (192/238 Pages) Microchip Technology – 14/16-Pin, Flash-Based 8-Bit CMOS Microcontrollers

PIC16F753/HV753
22.4 DC Characteristics: PIC16F753-I (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
Param.
No.
Device Characteristics
Min.
Typ†
Max.
Units
VDD
Conditions
Note
D020 Power-down Base
Current (IPD)⁽²⁾
— 0.01 TBD A
— 0.3 TBD A
PIC16F753 — 0.5 TBD A
2.0 WDT, BOR, Comparator, VREF and
T1OSC disabled
3.0
5.0
D021
150 TBD nA
— 3.0 TBD A
3.0 _{-40°C  TA  +25°C for industrial}
2.0 WDT Current⁽¹⁾
D022
D023
D024
— 4.0 TBD A
— 7.0 TBD A
— 5.0 TBD A
— 6.0 TBD A
— 362 TBD A
— 418 TBD A
— 500 TBD A
—
96 TBD A
— 112 TBD A
3.0
5.0
3.0 BOR Current⁽¹⁾
5.0
2.0 CxSP = 1, Comparator Current⁽¹⁾,
3.0 ^{single comparator enabled}
5.0
2.0 CxSP = 0, Comparator Current⁽¹⁾,
3.0 ^{single comparator enabled}
D025
D026
— 132 TBD A
— 0.3 TBD A
— 0.36 TBD A
— 0.2 TBD A
5.0
3.0 A/D Current⁽¹⁾, no conversion in
5.0 ^progress
3.0 DAC Current⁽¹⁾
D027
— 0.4 TBD A
—
59 TBD A
—
98 TBD A
5.0
3.0 FVR Current⁽¹⁾, FVRBUFEN = 1,
5.0 ^{REFOUT buffer enabled}
Legend: TBD = To Be Determined
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral  current can be determined by subtracting the base IDD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
D40001709A-page 192
Preliminary
 2013 Microchip Technology Inc.