PIC16F753 Datasheet, PDF (148/238 Pages) Microchip Technology – 14/16-Pin, Flash-Based 8-Bit CMOS Microcontrollers

PIC16F753/HV753
17.7 Register Definitions: Slope Compensation Control
REGISTER 17-1: SLPCCON0: SLOPE COMPENSATION CONTROL 0 REGISTER
R/W-0/0
U-0
SCxEN
—
bit 7
U-0
R/W-0/0 R/W-0/0
R/W-0/0
U-0
—
SCxPOL
SCxTSS<1:0>
—
R/W-0/0
SCxINS
bit 0
Legend:
R = Readable bit
u = Bit is unchanged
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
q = value depends on configuration bits
bit 7
bit 6-5
bit 4
bit 3-2
bit 1
bit 0
SCxEN: Slope Compensation Enable bit
1 = Slope compensation is enabled
0 = Slope compensation is disabled
Unimplemented: Read as ‘0’
SCxPOL: Slope Compensation Input Polarity bit
1 = Signal is inverted polarity (active-low)
0 = Signal is normal polarity (active-high)
SCxTSS<1:0>: Slope Compensation Timing Select bits
11 = C2OUT_sync
10 = C1OUT_sync
01 = COG1_output1
00 = COG1_output0
Unimplemented: Read as ‘0’
SCxINS: Slope Compensation Input Select bit
1 = FVR_buffer1 is selected
0 = SLPC1IN pin is selected
REGISTER 17-2: SLPCCON1: SLOPE COMPENSATION CONTROL 1 REGISTER
U-0
—
bit 7
U-0
U-0
R/W-0/0 R/W-0/0
R/W-0/0
R/W-0/0
—
—
SCxRNG
SCxISET<3:0>
R/W-0/0
bit 0
Legend:
R = Readable bit
u = Bit is unchanged
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
q = value depends on configuration bits
bit 7-5
bit 4
bit 3-0
Unimplemented: Read as ‘0’
SCxRNG: Slope Compensator Range bit
1 = Range setting is SCxISET * 0.75/15 +0.2V/s
0 = Range setting is SCxISET +1.0V/s
SCxISET<3:0>: Slope Compensator Current Sink Set bits
xxxxx = SC module Slope Selection
DS40001709A-page 148
Preliminary
 2013 Microchip Technology Inc.