|
PIC16F753 Datasheet, PDF (193/238 Pages) Microchip Technology – 14/16-Pin, Flash-Based 8-Bit CMOS Microcontrollers | |||
|
◁ |
PIC16F753/HV753
22.5 DC Characteristics: PIC16F753-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ï£ TA ï£ +125°C for extended
Param
No.
Device Characteristics
Min.
Typâ
Max.
Units
VDD
Conditions
Note
D020E Power-down Base
Current (IPD)(2)
PIC16F753
D021E
D022E
â 0.1 TBD ïA
â 0.3 TBD ïA
â 0.5 TBD ïA
â 3.0 TBD ïA
â 4.0 TBD ïA
â 7.0 TBD ïA
â 5.0 TBD ïA
2.0 WDT, BOR, Comparator, DAC and
3.0 FVR disabled
5.0
2.0 WDT Current(1)
3.0
5.0
3.0 BOR Current(1)
D023E
D024E
D025E
D026E
â 6.0 TBD ïA
â 362 TBD ïA
â 418 TBD ïA
â 500 TBD ïA
â
96 TBD ïA
â 112 TBD ïA
â 132 TBD ïA
â .03 TBD ïA
â 0.36 TBD ïA
â 0.2 TBD ïA
5.0
2.0 CxSP = 1, Comparator Current(1),
3.0 single comparator enabled
5.0
2.0 CxSP = 0, Comparator Current(1),
3.0 single comparator enabled
5.0
3.0 A/D Current(1), no conversion in
5.0 progress
3.0 DAC Current(1,3)
D027E
â 0.4 TBD ïA
â
59 TBD ïA
â
98 TBD ïA
5.0
3.0 FVR Current(1), FVRBUFEN = 1,
5.0 REFOUT buffer enabled
Legend: TBD = To Be Determined
* These parameters are characterized but not tested.
â Data in âTypâ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral ï current can be determined by subtracting the base IDD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
3: Both or one input reference are in high-Z state.
ï£ 2013 Microchip Technology Inc.
Preliminary
D40001709A-page 193
|
▷ |