PIC16F753 Datasheet, PDF (105/238 Pages) Microchip Technology – 14/16-Pin, Flash-Based 8-Bit CMOS Microcontrollers

PIC16F753/HV753
REGISTER 11-6: COGxFSIM: COG FALLING EVENT SOURCE INPUT MODE REGISTER
U-0
—
bit 7
R/W-0/0
GxFMHLT2
R/W-0/0
GxFMHLT1
R/W-0/0
GxFMT2M
R/W-0/0
GxFMFLT
R/W-0/0
GxFMCCP1
R/W-0/0
GxFMC2
R/W-0/0
GxFMC1
bit 0
Legend:
R = Readable bit
u = Bit is unchanged
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
q = Value depends on condition
bit 7
Unimplemented: Read as ‘0’
bit 6
GxFMHLT2: COGx Falling Event Input Source 6 Mode bit⁽¹⁾
GxFIHLT2 = 1:
1 = HLTimer2 low-to-high transition will cause a falling event after falling event phase delay
0 = HLTimer2 high level will cause an immediate falling event
GxFIHLT2 = 0:
HLTimer2 has no effect on falling event
bit 5
GxFMHLT1: COGx Falling Event Input Source 5 Mode bit⁽¹⁾
GxFIHLT1 = 1:
1 = HLTimer1 low-to-high transition will cause a falling event after falling event phase delay
0 = HLTimer1 high level will cause an immediate falling event
GxFIHLT1 = 0:
HLTimer1 has no effect on falling event
bit 4
GxFMT2M: COGx Falling Event Input Source 4 Mode bit⁽¹⁾
GxFIT2M = 1:
1 = Timer2 match with PR2 low-to-high transition will cause a falling event after falling event phase delay
0 = Timer2 match with PR2 high level will cause an immediate falling event
GxFIT2M = 0:
Timer2 match with PR2 has no effect on falling event
bit 3
GxFMFLT: COGx Falling Event Input Source 3 Mode bit
GxFIFLT = 1:
1 = COGxFLT pin low-to-high transition will cause a falling event after falling event phase delay
0 = COGxFLT pin high level will cause an immediate falling event
GxFIFLT = 0:
COGxFLT pin has no effect on falling event
bit 2
GxFMCCP1: COGx Falling Event Input Source 2 Mode bit
GxFICCP1 = 1:
1 = CCP1 low-to-high transition will cause a falling event after falling event phase delay
0 = CCP1 high level will cause an immediate falling event
GxFICCP1 = 0:
CCP1 has no effect on falling event
bit 1
GxFMC2: COGx Falling Event Input Source 1 Mode bit
GxFIC2 = 1:
1 = Comparator 2 low-to-high transition will cause a falling event after falling event phase delay
0 = Comparator 2 high level will cause an immediate falling event
GxFIC2 = 0:
Comparator 2 has no effect on falling event
bit 0
GxFMC1: COGx Falling Event Input Source 0 Mode bit
GxFIC1 = 1:
1 = Comparator 1 low-to-high transition will cause a falling event after falling event phase delay
0 = Comparator 1 high level will cause an immediate falling event
GxFIC1 = 0:
Comparator 1 has no effect on falling event
Note 1: These sources are pulses and therefore the only benefit of Edge mode over Level mode is that they can be
delayed by falling event phase delay.
 2013 Microchip Technology Inc.
Preliminary
DS40001709A-page 105