PIC16F753 Datasheet, PDF (194/238 Pages) Microchip Technology – 14/16-Pin, Flash-Based 8-Bit CMOS Microcontrollers

PIC16F753/HV753
22.6 DC Characteristics: PIC16HV753-I (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
Param.
No.
Device Characteristics
Min.
Typ†
Max.
Units
VDD
Conditions
Note
D020
D021
Power-down Base
Current (IPD)^(2,3)
PIC16HV753
D022
— 135 TBD A
— 210 TBD A
— 260 TBD A
— 135 TBD A
— 210 TBD A
— 265 TBD A
— 215 TBD A
2.0 WDT, BOR, Comparator, DAC and
3.0 ^{FVR disabled}
4.5
2.0 WDT Current⁽¹⁾
3.0
4.5
3.0 BOR Current⁽¹⁾
D023
D024
D025
D026
— 265 TBD A
— 362 TBD A
— 418 TBD A
— 450 TBD A
—
90 TBD A
— 107 TBD A
— 127 TBD A
— 210 TBD A
— 260 TBD A
— 215 TBD A
4.5
2.0 CxSP = 1, Comparator Current⁽¹⁾,
3.0 ^{single comparator enabled}
4.5
2.0 CxSP = 0, Comparator Current⁽¹⁾,
3.0 ^{single comparator enabled}
4.5
3.0 A/D Current⁽¹⁾, no conversion in
4.5 ^progress
3.0 DAC Current⁽¹⁾
D027
— 265 TBD A
— 485 TBD A
— 615 TBD A
4.5
3.0 FVR Current⁽¹⁾, FVRBUFEN = 1,
4.5 ^{REFOUT buffer enabled}
Legend: TBD = To Be Determined
* These parameters are characterized but not tested.
† Data in “Typ” column is at 4.5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral  current can be determined by subtracting the base IDD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD.
3: Shunt regulator is always on and always draws operating current.
D40001709A-page 194
Preliminary
 2013 Microchip Technology Inc.