TLE94106EL Datasheet, PDF (14/75 Pages) Infineon Technologies AG – Six half bridge power outputs

TLE94106EL
General Product Characteristics
Table 5
Electrical Characteristics, V_S =5.5 V to 18 V, V_DD = 3.0V to 5.5V, T_j = -40°C to +150°C, EN= HIGH,
I_OUTn= 0 A; Typical values refer to V_DD = 5.0 V, V_S = 13.5 V and T_J = 25 °C unless otherwise
specified; all voltages with respect to ground, positive current flowing into pin (unless
otherwise specified) (cont’d)
Parameter
Symbol
Values
Unit Note or
Min. Typ. Max.
Test Condition
High-Side R_DSON
(HS1 and HS2 in LED mode)
High-Side R_DSON
(HS1 and HS2 in LED mode)
R_{DSON_HI_HB_} –
25C
R_{DSON_HI_HB_} –
150C
950 1300 mΩ
1500 2000 mΩ
2) _{IOUT = ±0.1 A;}
T_j = 25 °C
2) _{IOUT = ±0.1 A;}
T_j = 150 °C
Output Protection and Diagnosis of high-side (HS) channels of half-bridge output
Number
P_4.4.18
P_4.4.19
HS Overcurrent Shutdown
Threshold
Difference between shutdown
and limit current
Overcurrent Shutdown filter
time
I_{SD_HS}
I_{LIM_HS} -
I_{SD_HS}
t_{dSD_HS}
-1.4 -1.1 -0.9 A
-1.2 -0.6 0
A
15 19 23 µs
See Figure 7
P_4.4.89
3) _{|ILIM_HS| ≥ |ISD_HS|}
See Figure 7
3)
P_4.4.21
P_4.4.22
Open Load Detection Current I_{OLD1_HS}
Open Load Detection filter time t_{OLD1_HS}
Open Load Detection Current I_{OLD2_HS1,2}
for LED mode
(HS1 & HS2)
-15 -8 -3 mA
2000 3000 4000 µs
-3.2 -2 -0.5 mA
-
3)
Bit OL_SEL_HS1 =
1, OL_SEL_HS2 = 1
P_4.4.23
P_4.4.24
P_4.4.25
Open Load Detection filter time t_{OLD2_HS1,2} 100 200 300 µs
for LED mode
(HS1 & HS2)
Bit OL_SEL_HS1 = P_4.4.26
1, OL_SEL_HS2 = 1;
3)
Output Protection and Diagnosis of low-side (LS) channels of half-bridge output
LS Overcurrent Shutdown
Threshold
Difference between shutdown
and limit current
Overcurrent Shutdown filter
time
I_{SD_LS}
I_{LIM_LS} -
I_{SD_LS}
t_{dSD_LS}
0.9 1.1 1.4 A
0
0.6 1.2 A
15 19 23 µs
Figure 8
3) _{ILIM_LS ≥ ISD_LS}
Figure 8
3)
P_4.4.104
P_4.4.28
P_4.4.29
Open Load Detection Current I_{OLD_LS}
Open Load Detection filter time t_{OLD_LS}
Outputs OUT(1...n) leakage current
3
8 15 mA -
2000 3000 4000 µs ³⁾
P_4.4.30
P_4.4.31
HS leakage current in off state I_{QLHn_NOR} -2
-0.5 –
HS leakage current in off state I_{QLHn_SLE} -2
-0.5 –
LS Leakage current in off state I_{QLLn_NOR} –
0.5 2
LS Leakage current in off state I_{QLLn_SLE}
–
0.5 2
Output Switching Times. See Figure 9 and Figure 10.
µA V_OUTn = 0V ; EN=High P_4.4.32
µA V_OUTn = 0V; EN=GND P_4.4.33
µA V_OUTn = V_S ; EN=High P_4.4.34
µA V_OUTn = V_S ; EN=GND P_4.4.35
Slew rate of high-side and low- d_VOUT/ dt 0.1
side outputs
0.45 0.75 V/µs Resistive load = P_4.4.36
100Ω; V_S=13.5V ⁴⁾
Data Sheet
14
1.0
2016-09-08