IC-MN_16 Datasheet, PDF (60/62 Pages) IC-Haus GmbH – 25-BIT NONIUS ENCODER WITH 3-CH. SAMPLING 13-BIT Sin/D INTERPOLATION

iC-MN 25-BIT NONIUS ENCODER
WITH 3-CH. SAMPLING 13-BIT Sin/D INTERPOLATION
Rev F2, Page 60/62
REVISION HISTORY
Rel. Rel. Date^∗ Chapter
D1 2010-06-15 ...
Modification
Page
Rel. Rel. Date^∗ Chapter
E1 2012-07-24 ELECTRICAL
CHARACTERISTICS
S/D CONVERSION with NONIUS
CALCULATION
I/O INTERFACE with EXTENDED
FUNCTIONS
COMMAND and STATUS
REGISTERS
MT INTERFACE
PRESET FUNCTION
EEPROM INTERFACE
DESIGN REVIEW: Notes On Chip
Functions
Modification
Item 109 (internal): max value
Items D05: values, H06: typ. value
Items K05, K07: conditions corrected
Item L05, L02: values
Items M01 to M03, conditions: input function MTMA
T3-triggered conversion: rising edge supplemented
Tab. 61, GRAY_SCD: for BiSS C only binary coded data;
CRC description: coverage of (MT+ST)+ERR+WARN, inverted CRC transmission;
Tab. 65, NC_BiSS: correction of Addr 0x43 to bit 5
Notice box and attention box on WRITE_CONF and SOFT_PRES
Fig. 19 splitted into Fig. 19+20;
Description of error handling: wait time of 128 µs supplemented;
Fig. 25: switching points and binary data supplemented
Notice box on SOFT_PRES (and pin PRES) regarding BiSS access;
Notice box on SOFT_PRES regarding loss of configuration on power failure
Text supplement: address range of 0x00 to 0x4D protected by CRC;
EEPROM I2C address range supplemented (11 bit max.)
Item 1 on signal level control added; Item 2 on bank access added
Page
7ff
31
39
42
48
51
55
59
Rel. Rel. Date^∗ Chapter
F1 2014-03-24 FEATURES
DESCRIPTION
ELECTRICAL
CHARACTERISTICS
REGISTER MAP (EEPROM)
ANALOG PARAMETERS
EEPROM INTERFACE
APPLICATION NOTES:
Configuration As BiSS C-Slave
Including EDS (Electronic Data
Sheet)
DESIGN REVIEW: Notes On Chip
Functions
REVISION HISTORY
Modification
Operating temperature range up to 110 °C
BiSS User License information supplemented
Item 405: symbol and name
Items 406, 407: conditions
Item 410: new entry for settling time
Item 505: symbol and name, min/max values
Items 506, 507: conditions
Items 605: conditions
Item 702: new entry for controlled output amplitude
Item 901, VDDon: shift of values towards 4.5 V
Item 902, VDDoff: shift of values towards 4.2 V
Item A01, fosc: min/max values
Item D08, I2C clock: min/max values
Improved description of ROM and EEPROM addresses
Function note on signal level controlling
Direct addressing: correction of address range (to 0x74)
Conditions edited (re. 1.)
Tab. MN Y2: Elec. Char. Items 901 and 902 listed (as of D1/E1 datasheet releases)
Tab. MN Y5 added: entry added for MT interface (additional clock pulse for SSI)
Document revision history introduced as new chapter.
Page
1
2
7ff
20
27
55
58
59
60