MC7457RX1267LC Datasheet, PDF(55/71 Page) Freescale Semiconductor, Inc

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

MC7457RX1267LC Datasheet, PDF (55/71 Pages) Freescale Semiconductor, Inc – Microprocessor

◁

System Design Information

response time necessary. They should also be connected to the power and ground planes through two vias

to minimize inductance. Suggested bulk capacitors: 100â330 ÂµF (AVX TPS tantalum or Sanyo OSCON).

9.4 Connection Recommendations

To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal

level. Unused active low inputs should be tied to OVDD. Unused active high inputs should be connected

to GND. All NC (no-connect) signals must remain unconnected.

Power and ground connections must be made to all external VDD, OVDD, GVDD, and GND pins in the

MPC7457. If the L3 interface is not used, GVDD should be connected to the OVDD power plane, and

L3VSEL should be connected to BVSEL; the remainder of the L3 interface may be left unterminated.

9.5 Output Buffer DC Impedance

The MPC7457 processor bus and L3 I/O drivers are characterized over process, voltage, and temperature.

To measure Z0, an external resistor is connected from the chip pad to OVDD or GND. Then, the value of

each resistor is varied until the pad voltage is OVDD/2 (see Figure 25).

The output impedance is the average of two components, the resistances of the pull-up and pull-down

devices. When data is held low, SW2 is closed (SW1 is open), and RN is trimmed until the voltage at the

pad equals OVDD/2. RN then becomes the resistance of the pull-down devices. When data is held high,

SW1 is closed (SW2 is open), and RP is trimmed until the voltage at the pad equals OVDD/2. RP then

becomes the resistance of the pull-up devices. RP and RN are designed to be close to each other in value.

Then, Z0 = (RP + RN)/2.

OVDD

Data

SW2

Pad

SW1

OGND

Figure 25. Driver Impedance Measurement

Table 21 summarizes the signal impedance results. The impedance increases with junction temperature

and is relatively unaffected by bus voltage.

MPC7457 RISC Microprocessor Hardware Specifications, Rev. 8

Freescale Semiconductor

▷