|
EPM240_10 Datasheet, PDF (26/88 Pages) Altera Corporation – MAX II Device Family Data | |||
|
◁ |
2â18
Figure 2â14. Global Clock Network (Note 1)
I/O Block Region
4
4
4
4
4
Chapter 2: MAX II Architecture
User Flash Memory Block
4
4
4
LAB Column
clock[3..0]
LAB Column
clock[3..0]
I/O Block Region
UFM Block (2)
CFM Block
Notes to Figure 2â14:
(1) LAB column clocks in I/O block regions provide high fan-out output enable signals.
(2) LAB column clocks drive to the UFM block.
I/O Block Region
User Flash Memory Block
MAX II devices feature a single UFM block, which can be used like a serial EEPROM
for storing non-volatile information up to 8,192 bits. The UFM block connects to the
logic array through the MultiTrack interconnect, allowing any LE to interface to the
UFM block. Figure 2â15 shows the UFM block and interface signals. The logic array is
used to create customer interface or protocol logic to interface the UFM block data
outside of the device. The UFM block offers the following features:
â Non-volatile storage up to 16-bit wide and 8,192 total bits
â Two sectors for partitioned sector erase
â Built-in internal oscillator that optionally drives logic array
â Program, erase, and busy signals
MAX II Device Handbook
© October 2008 Altera Corporation
|
▷ |