AK4695 Datasheet, PDF (54/107 Pages) Asahi Kasei Microsystems – 24bit 4ch CODEC with MIC/HP/SPK/LINE-AMP

[AK4695]
(2) Middle Frequency Range
Bypass (DMHPF1-0 = DMLPF1-0 bits = “00”)
HPF
LPF
VOLM
DVLCM
DMHPF1-0
DMHA13-0
DMHB13-0
DMLPF1-0
DMLA13-0
DMLB13-0
VM1X/Y5-0
VM2X/Y5-0
VM3X/Y4-0
M1G6-0
M2G6-0
M3G6-0
M4G6-0
Figure 36. DVLC Functions and Signal Path for Middle Frequency Range
(2-1) High Pass Filter (HPF)
This is composed with 1st or 2nd order HPF. The coefficient of HPF is set by DMHA13-0 bits and DMHB13-0 bits. HPF
bit controls ON/OFF of the HPF. When the HPF is OFF, the audio data passes this block by 0dB gain. The coefficient must
be set when DMHPF1-0 bits = “00” or PMDRC bit = “0”. The HPF starts operation 4/fs(max) after when DMHPF1-0 bits
= “01” or “10” and PMDRC bit = “1” are set.
DMHPF1 bit DMHPF0 bit
Mode
0
0
Bypass
(default)
0
1
1st order HPF
1
0
2nd order HPF
1
1
N/A
Table 51. DMHPF Mode Setting (N/A: Not Available)
fs: Sampling frequency
fc: Cut-off frequency
Register setting
HPF: DMHA[13:0] bits =A, DMHB[13:0] bits =B
(MSB=DMHA13, DMHB13; LSB=DMHA0, DMHB0)
1 / tan (fc/fs)
A=
,
1 + 1 / tan (fc/fs)
1  1 / tan (fc/fs)
B=
1 + 1 / tan (fc/fs)
Transfer function (1st order)
1  z ^1
H(z) = A
1 + Bz ^1
Transfer function (2nd order)
1  z ^1
1  z ^1
H(z) = A
xA
1 + Bz ^1
1 + Bz ^1
The cut-off frequency should be set as below.
fc/fs  0.0001 (fc min = 4.8Hz at 48kHz)
MS1463-E-01
- 54 -
2014/12