AK4648 Datasheet, PDF (10/119 Pages) Asahi Kasei Microsystems – Stereo CODEC with MIC/HP/SPK-AMP

[AK4648]
RECOMMENDED OPERATING CONDITIONS
(VSS1, VSS2, VSS3=0V; Note 4)
Parameter
Symbol
min
typ
Power Supplies Analog
AVDD
2.6
3.3
(Note 11) Digital
DVDD
2.6
3.3
Digital I/O
TVDD
1.6
3.3
HP/SPK-Amp
HVDD
2.6
3.6
Difference
AVDD−DVDD
−0.3
0
max
3.6
3.6
DVDD
5.0
+0.3
Units
V
V
V
V
V
Note 4. All voltages with respect to ground.
Note 11. The power-up sequence among AVDD, DVDD, TVDD, and HVDD is not critical. PDN pin should be held to
“L” upon power-up. PDN pin should be set to “H” after all power supplies are powered-up.The AK4648 should be
operated by the recommended power-up/down sequence shown in “System Design (Grounding and Power Supply
Decoupling)” to avoid the pop noise at speaker output, line output and headphone output.
The AK4648 supports the following two cases of partial power ON/OFF. In these cases, the
PDN pin must be “L”.
1. TVDD=HVDD=ON: AVDD=DVDD can be power ON/OFF.
2. TVDD=ON: AVDD=DVDD=HVDD can be power ON/OFF.
When the power state is changed from OFF to ON in the above cases, the PDN pin should be
changed from “L” to”H” after all power supply pins are supplied. “L” time of 150ns or more is
needed to reset the AK4648.
* AKEMD assumes no responsibility for the usage beyond the conditions in this datasheet.
MS0625-E-01
- 10 -
2007/06