S71GL032A Datasheet, PDF (70/102 Pages) SPANSION – Stacked Multi-Chip Product (MCP) Flash Memory and RAM

Advance Information
Erase and Program Operations-S29GL064A Only
Parameter
JEDEC
Std.
Description
t_AVAV
t_WC
Write Cycle Time (Note 1)
Min
t_AVWL
t_AS
Address Setup Time
Min
t_ASO
Address Setup Time to OE# low during toggle bit polling
Min
t_WLAX
t_AH
Address Hold Time
Min
t_AHT
Address Hold Time From CE# or OE# high during toggle bit polling Min
t_DVWH
t_DS
Data Setup Time
Min
t_WHDX
t_DH
Data Hold Time
Min
t_CEPH
CE# High during toggle bit polling
Min
t_OEPH
OE# High during toggle bit polling
Min
t_GHWL
t_GHWL
Read Recovery Time Before Write (OE# High to WE# Low)
Min
t_ELWL
t_CS
CE# Setup Time
Min
t_WHEH
t_CH
CE# Hold Time
Min
t_WLWH
t_WP
Write Pulse Width
Min
t_WHDL
t_WPH
Write Pulse Width High
Min
Write Buffer Program Operation (Notes 2, 3)
Typ
t_WHWH1
t_WHWH1 Single Word Program Operation (Note 2)
Typ
Accelerated Single Word Program Operation (Note 2)
Typ
t_WHWH2
t_WHWH2 Sector Erase Operation (Note 2)
Typ
t_VHH
V_HH Rise and Fall Time (Note 1)
Min
t_VCS
V_CC Setup Time (Note 1)
Min
t_BUSY
WE# High to RY/BY# Low
Min
t_POLL
Program Valid before Status Polling
Max
Speed Options
90
10
11
90
100
110
0
15
45
0
35
0
20
20
0
0
0
35
30
240
60
54
0.5
250
50
90
100
110
4
Unit
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
µs
sec
ns
µs
ns
µs
Notes:
1. Not 100% tested.
2. See the “Erase and Programming Performance” section for more information.
3. For 1–16 words/1–32 bytes programmed.
4. If a program suspend command is issued within t_POLL, the device requires t_POLL before reading status data, once
programming has resumed (that is, the program resume command has been written). If the suspend command was issued
after t_POLL, status data is available immediately after programming has resumed. See Figure 16.
70
S71GL032A Based MCPs
S71GL032A_00_A0 March 31, 2005