LAN9313 Datasheet, PDF (234/398 Pages) SMSC Corporation – Three Port 10/100 Managed Ethernet Switch with MII

Three Port 10/100 Managed Ethernet Switch with MII
Datasheet
BITS
DESCRIPTION
9 Restart Auto-Negotiation (PHY_RST_AN)
When set, this bit restarts the Auto-Negotiation process.
0: Normal operation
1: Auto-Negotiation restarted
8 Duplex Mode (PHY_DUPLEX)
This bit is used to set the duplex when the Auto-Negotiation (PHY_AN) bit
is disabled.
0: Half Duplex
1: Full Duplex
7 Collision Test Mode (PHY_COL_TEST)
This bit enables/disables the collision test mode of the Port x PHY. When
set, the collision signal is active during transmission. It is recommended that
this feature be used only in loopback mode.
0: Collision test mode disabled
1: Collision test mode enabled
6:0 RESERVED
TYPE
R/W
SC
R/W
R/W
RO
DEFAULT
0b
Note 13.53
0b
-
Note 13.51 The default value of this bit is determined by the logical OR of the Auto-Negotiation strap
(autoneg_strap_1 for Port 1 PHY, autoneg_strap_2 for Port 2 PHY) and the speed select
strap (speed_strap_1 for Port 1 PHY, speed_strap_2 for Port 2 PHY). Essentially, if the
Auto-Negotiation strap is set, the default value is 1, otherwise the default is determined by
the value of the speed select strap. Refer to Section 4.2.4, "Configuration Straps," on
page 45 for more information.
Note 13.52 The default value of this bit is determined by the value of the Auto-Negotiation strap
(autoneg_strap_1 for Port 1 PHY, autoneg_strap_2 for Port 2 PHY). Refer to Section 4.2.4,
"Configuration Straps," on page 45 for more information.
Note 13.53 The default value of this bit is determined by the logical AND of the negation of the Auto-
Negotiation strap (autoneg_strap_1 for Port 1 PHY, autoneg_strap_2 for Port 2 PHY) and
the duplex select strap (duplex_strap_1 for Port 1 PHY, duplex_strap_2 for Port 2 PHY).
Essentially, if the Auto-Negotiation strap is set, the default value is 0, otherwise the default
is determined by the value of the duplex select strap. Refer to Section 4.2.4, "Configuration
Straps," on page 45 for more information.
Revision 1.2 (04-08-08)
234
DATASHEET
SMSC LAN9313/LAN9313i