LAN9313 Datasheet, PDF (16/398 Pages) SMSC Corporation – Three Port 10/100 Managed Ethernet Switch with MII

Three Port 10/100 Managed Ethernet Switch with MII
Datasheet
1.2
Buffer Types
Table 1.1 describes the pin buffer type notation used in Chapter 3, "Pin Description and Configuration,"
on page 26 and throughout this document.
Table 1.1 Buffer Types
BUFFER TYPE
IS
O8
OD8
O12
OD12
PU
PD
AI
AO
AIO
ICLK
OCLK
P
DESCRIPTION
Schmitt-triggered Input
Output with 8mA sink and 8mA source
Open-drain output with 8mA sink
Output with 12mA sink and 12mA source
Open-drain output with 12mA sink
50uA (typical) internal pull-up. Unless otherwise noted in the pin description, internal pull-
ups are always enabled.
Note:
Internal pull-up resistors prevent unconnected inputs from floating. Do not rely on
internal resistors to drive signals external to the LAN9313/LAN9313i. When
connected to a load that must be pulled high, an external resistor must be added.
50uA (typical) internal pull-down. Unless otherwise noted in the pin description, internal
pull-downs are always enabled.
Note:
Internal pull-down resistors prevent unconnected inputs from floating. Do not rely
on internal resistors to drive signals external to the LAN9313/LAN9313i. When
connected to a load that must be pulled low, an external resistor must be added.
Analog input
Analog output
Analog bi-directional
Crystal oscillator input pin
Crystal oscillator output pin
Power pin
Revision 1.2 (04-08-08)
16
DATASHEET
SMSC LAN9313/LAN9313i