LAN9313 Datasheet, PDF (190/398 Pages) SMSC Corporation – Three Port 10/100 Managed Ethernet Switch with MII

Three Port 10/100 Managed Ethernet Switch with MII
Datasheet
BITS
3
2
1
0
DESCRIPTION
1588 Port 0(External MII) TX Interrupt (1588_MII_TX_INT)
This interrupt indicates that a packet from the External MII to the switch
fabric matches the configured PTP packet and the 1588 clock was captured.
Note: For Port 0, receive is defined as data from the switch fabric, while
transmit is to the switch fabric.
1588 GPIO9 Interrupt (1588_GPIO9_INT)
This interrupt indicates that an event on GPIO9 occurred and the 1588 clock
was captured. These interrupts are configured through the General Purpose
I/O Configuration Register (GPIO_CFG) register.
Note:
As 1588 capture inputs, GPIO inputs are edge sensitive and must
be active for greater than 40 nS to be recognized as interrupt
inputs.
1588 GPIO8 Interrupt (1588_GPIO8_INT)
This interrupt indicates that an event on GPIO8 occurred and the 1588 clock
was captured. These interrupts are configured through the General Purpose
I/O Configuration Register (GPIO_CFG) register.
Note:
As 1588 capture inputs, GPIO inputs are edge sensitive and must
be active for greater than 40 nS to be recognized as interrupt
inputs.
1588 Timer Interrupt (1588_TIMER_INT)
This interrupt indicates that the 1588 clock equaled or passed the Clock
Target value in the 1588 Clock Target High-DWORD Register
(1588_CLOCK_TARGET_HI) and 1588 Clock Target Low-DWORD Register
(1588_CLOCK_TARGET_LO).
Note:
This bit is also cleared by an active edge on GPIO[9:8] if enabled.
For the clear function, GPIO inputs are edge sensitive and must be
active for greater than 40 nS to be recognized as a clear input.
Refer to Section 12.2, "GPIO Operation," on page 142 for
additional information.
TYPE
R/WC
R/WC
R/WC
R/WC
DEFAULT
0b
0b
0b
0b
Revision 1.2 (04-08-08)
190
DATASHEET
SMSC LAN9313/LAN9313i