LAN9313 Datasheet, PDF (158/398 Pages) SMSC Corporation – Three Port 10/100 Managed Ethernet Switch with MII

13.1.2.3
Three Port 10/100 Managed Ethernet Switch with MII
Datasheet
General Purpose I/O Interrupt Status and Enable Register (GPIO_INT_STS_EN)
Offset:
1E8h
Size:
32 bits
This read/write register contains the GPIO interrupt status bits.
Writing a 1 to any of the interrupt status bits acknowledges and clears the interrupt. If enabled, these
interrupt bits are cascaded into bit 12 (GPIO) of the Interrupt Status Register (INT_STS). Writing a 1
to any of the interrupt enable bits will enable the corresponding interrupt as a source. Status bits will
still reflect the status of the interrupt source regardless of whether the source is enabled as an interrupt
in this register. Bit 12 (GPIO_EN) of the Interrupt Enable Register (INT_EN) must also be set in order
for an actual system level interrupt to occur. Refer to Chapter 5, "System Interrupts," on page 52 for
additional information.
BITS
DESCRIPTION
31:28
27:16
15:12
11:0
RESERVED
GPIO Interrupt Enable[11:0] (GPIO[11:0]_INT_EN)
When set, these bits enable the corresponding GPIO interrupt.
Note:
The GPIO interrupts must also be enabled via bit 12 (GPIO_EN) of
the Interrupt Enable Register (INT_EN) in order to cause the
interrupt pin (IRQ) to be asserted.
RESERVED
GPIO Interrupt[11:0] (GPIO[11:0]_INT)
These signals reflect the interrupt status as generated by the GPIOs. These
interrupts are configured through the General Purpose I/O Configuration
Register (GPIO_CFG).
Note: As GPIO interrupts, GPIO inputs are level sensitive and must be
active greater than 40 nS to be recognized as interrupt inputs.
TYPE
RO
R/W
RO
R/WC
DEFAULT
-
0h
-
0h
Revision 1.2 (04-08-08)
158
DATASHEET
SMSC LAN9313/LAN9313i