HD64F3694HV Datasheet, PDF (119/452 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Tiny Series

Section 7 ROM
7.2.1 Flash Memory Control Register 1 (FLMCR1)
FLMCR1 is a register that makes the flash memory change to program mode, program-verify
mode, erase mode, or erase-verify mode. For details on register setting, refer to section 7.4, Flash
Memory Programming/Erasing.
Initial
Bit
Bit Name Value R/W Description
7
—
0
—
Reserved
This bit is always read as 0.
6
SWE
0
R/W Software Write Enable
When this bit is set to 1, flash memory
programming/erasing is enabled. When this bit is cleared
to 0, other FLMCR1 register bits and all EBR1 bits cannot
be set.
5
ESU
0
R/W Erase Setup
When this bit is set to 1, the flash memory changes to the
erase setup state. When it is cleared to 0, the erase
setup state is cancelled. Set this bit to 1 before setting the
E bit to 1 in FLMCR1.
4
PSU
0
R/W Program Setup
When this bit is set to 1, the flash memory changes to the
program setup state. When it is cleared to 0, the program
setup state is cancelled. Set this bit to 1 before setting
the P bit in FLMCR1.
3
EV
0
R/W Erase-Verify
When this bit is set to 1, the flash memory changes to
erase-verify mode. When it is cleared to 0, erase-verify
mode is cancelled.
2
PV
0
R/W Program-Verify
When this bit is set to 1, the flash memory changes to
program-verify mode. When it is cleared to 0, program-
verify mode is cancelled.
1
E
0
R/W Erase
When this bit is set to 1, and while the SWE=1 and
ESU=1 bits are 1, the flash memory changes to erase
mode. When it is cleared to 0, erase mode is cancelled.
Rev.5.00 Nov. 02, 2005 Page 89 of 418
REJ09B0028-0500