306666-11 Datasheet, PDF (5/99 Pages) Numonyx B.V – Numonyx StrataFlash Embedded Memory

P30
Revision History
Revision Date
April 2005
August 2005
September 2005
November 2005
February 2006
April 2006
May 2006
May-2006
June - 2007
November 2007
November 2007
Revision
-001
-002
-003
-004
-005
-006
-007
-008
-009
-010
11
Description
Initial Release
Revised discrete memory maps in Section 4.4, “Memory Maps” on page 22
Added memory maps for 512-Mbit top parameter devices in Section 4.4, “Memory
Maps” on page 22
Fixed size of Programming Region for 256-Mbit to be 8-Mbit in Section 4.4, “Memory
Maps” on page 22 and Section 11.0, “Programming Operations” on page 56
Removed power supply sequencing requirement in Section 8.1, “Power-Up and Power-
Down” on page 41
Updated conditions for Table 15, “Capacitance” on page 29
Updated CFI table in Appendix C, “Common Flash Interface”
Added note to Table 34, “Device ID codes” on page 71 for stacked Device ID codes
Synchronous burst read operation is currently not supported for the TSOP package
Updated 512-Mbit Easy BGA Ball Height (symbol A1) in Figure 2, “Easy BGA Mechanical
Specifications” on page 11
Updated read access speed for 265M TSOP package
Removed all references to 1 Gigabit.
• Added 52 MHz capabilities,
• Added TSOP Package information for 512 Mb throughout the document,
• Added Section 2.1, “Virtual Chip Enable Description” on page 8,
• Modified figures in Section 4.3, “Dual-Die Configurations” on page 21,
• Modified Table 9, “512-Mbit Top and Bottom Parameter Memory Map (Easy BGA and
QUAD+ SCSP)” on page 23,
• Modified Notes 5 & 6 to Reset Specifications table in Section 8.2, “Reset
Specifications” on page 41,
• Added additional note on 512 Mb capability in Table 31, “Selectable OTP Block
Mapping” on page 66.
• Updated the following tables to 52 MHz: Table 16, “AC Read Specifications for 64/
128- Mbit Densities” on page 29 and Table 17, “AC Read Specifications for 256/512-Mbit
Densities” on page 30.
• Added notes 1, 2, and 3 to Table 15, “Capacitance” on page 29.
• Correct typos and add clarifications
• Enabled specific burst operation on TSOP packages.
• Updated device commands table.
• Updaed description on synchronous burst operation.
• Added EOWL description.
• Updated flowcharts
• Updated for 65nm lithography
• Added W602 - Erase to Suspend
• Applied Numonyx branding.
November 2007
Order Number: 306666-11
Datasheet
5