LAN8700 Datasheet, PDF (37/74 Pages) SMSC Corporation – ±15kV ESD Protected MII/RMII Fast-Ethernet PHY with HP Auto-MDIX and SMSC flexPWR TM in a Small Footprint

LAN8700/LAN8700i
TABLE 5-35: REGISTER 5 - AUTO NEGOTIATION LINK PARTNER ABILITY (CONTINUED)
Address
Name
Description
Mode Default
5.10
5.9
5.8
5.7
5.6
5.5
5.4:0
Pause Operation 1 = Pause Operation is supported by remote MAC,
RO
0 = Pause Operation is not supported by remote MAC
100Base-T4 1 = T4 able,
RO
0 = no T4 ability.
This Phy does not support T4 ability.
100Base-TX Full 1 = TX with full duplex,
RO
Duplex
0 = no TX full duplex ability
100Base-TX 1 = TX able,
RO
0 = no TX ability
10Base-T Full 1 = 10Mbps with full duplex
RO
Duplex
0 = no 10Mbps with full duplex ability
10Base-T
1 = 10Mbps able,
RO
0 = no 10Mbps ability
Selector Field [00001] = IEEE 802.3
RO
0
0
0
0
0
0
00001
TABLE 5-36: REGISTER 6 - AUTO NEGOTIATION EXPANSION
Address
Name
Description
6.15:5
6.4
6.3
6.2
6.1
Reserved
Parallel Detection
Fault
Link Partner Next
Page Able
Next Page Able
Page Received
1 = fault detected by parallel detection logic
0 = no fault detected by parallel detection logic
1 = link partner has next page ability
0 = link partner does not have next page ability
1 = local device has next page ability
0 = local device does not have next page ability
1 = new page received
0 = new page not yet received
6.0
Link Partner Auto- 1 = link partner has auto-negotiation ability
Negotiation Able ^{0 = link partner does not have auto-negotiation ability}
Mode
RO
RO/
LH
RO
RO
RO/
LH
RO
Default
0
0
0
0
0
0
TABLE 5-37: REGISTER 16 - SILICON REVISION
Address
Name
Description
16.15:10
16.9:6
16.5:0
Reserved
Silicon Revision
Reserved
Four-bit silicon revision identifier.
Mode
RO
RO
RO
Default
0
0001
0
TABLE 5-38:
Address
17.15:14
17.13
17.12
17.11
REGISTER 17 - MODE CONTROL/STATUS
Name
Description
Reserved
EDPWRDOWN
Reserved
LOWSQEN
Write as 0; ignore on read.
Enable the Energy Detect Power-Down mode:
0 = Energy Detect Power-Down is disabled
1 = Energy Detect Power-Down is enabled
Write as 0, ignore on read
The Low_Squelch signal is equal to LOWSQEN AND
EDPWRDOWN.
Low_Squelch = 1 implies a lower threshold
(more sensitive).
Low_Squelch = 0 implies a higher threshold
(less sensitive).
Mode
RW
RW
RW
RW
Default
0
0
0
0
 2007-2016 Microchip Technology Inc.
DS00002260A-page 37