PIC24HJ12GP201_11 Datasheet, PDF (194/262 Pages) Microchip Technology – High-Performance, 16-bit Microcontrollers 5-cycle latency

PIC24HJ12GP201/202
TABLE 22-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤TA ≤ +85°C for Industrial
-40°C ≤TA ≤+125°C for Extended
Param
No.
Symbol
Characteristic
IIL
DI50
Input Leakage Current^(2,3)
I/O Pins 5V Tolerant⁽⁴⁾
DI51
I/O Pins Not 5V Tolerant⁽⁴⁾
DI51a
DI51b
I/O Pins Not 5V Tolerant⁽⁴⁾
I/O Pins Not 5V Tolerant⁽⁴⁾
DI51c
I/O Pins Not 5V Tolerant⁽⁴⁾
Min Typ⁽¹⁾ Max Units
Conditions
—
—
±2
μA VSS ≤VPIN ≤VDD,
Pin at high-impedance
—
—
±1
μA VSS ≤VPIN ≤VDD,
Pin at high-impedance,
-40°C ≤TA ≤+85°C
—
—
±2
μA Shared with external reference
pins, -40°C ≤TA ≤+85°C
—
—
±3.5
μA VSS ≤VPIN ≤VDD, Pin at
high-impedance,
-40°C ≤TA ≤+125°C
—
—
±8
μA Analog pins shared with
external reference pins,
-40°C ≤TA ≤+125°C
DI55
MCLR
—
—
±2
μA VSS ≤VPIN ≤VDD
DI56
OSC1
—
—
±2
μA VSS ≤VPIN ≤VDD,
XT and HS modes
Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: See “Pin Diagrams” for a list of 5V tolerant pins.
5: VIL source < (VSS – 0.3). Characterized but not tested.
6: Non-5V tolerant pins VIH source > (VDD + 0.3), 5V tolerant pins VIH source > 5.5V. Characterized but not
tested.
7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5.5V.
8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.
9: Any number and/or combination of I/O pins not excluded under IICL or IICH conditions are permitted pro-
vided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not
exceed the specified limit. Characterized but not tested.
10: These parameters are characterized, but not tested.
DS70282E-page 194
© 2007-2011 Microchip Technology Inc.