PIC24HJ12GP201_11 Datasheet, PDF (193/262 Pages) Microchip Technology – High-Performance, 16-bit Microcontrollers 5-cycle latency

PIC24HJ12GP201/202
TABLE 22-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤TA ≤ +85°C for Industrial
-40°C ≤TA ≤+125°C for Extended
Param
No.
Symbol
Characteristic
Min Typ⁽¹⁾ Max Units
Conditions
VIL
Input Low Voltage
DI10
I/O pins
VSS
— 0.2 VDD V
DI15
MCLR
VSS
— 0.2 VDD V
DI16
I/O Pins with OSC1 or SOSCI VSS
— 0.2 VDD V
DI18
SDA, SCL
VSS
— 0.3 VDD V SMBus disabled
DI19
VIH
DI20
SDA, SCL
VSS
—
0.8
V SMBus enabled
Input High Voltage⁽¹⁰⁾
I/O Pins Not 5V Tolerant⁽⁴⁾ 0.7 VDD —
VDD
V
I/O Pins 5V Tolerant⁽⁴⁾
0.7 VDD —
5.5
V
DI21
I/O Pin with Schmitt Trigger 0.7 VDD — 0.8 VDD V
Input
DI25
MCLR
0.8 VDD —
VDD
V
DI26
OSC1 (in XT, HS, and LP
modes)
0.7 VDD —
VDD
V
DI27
OSC1 (in RC mode)
0.9 VDD —
VDD
V
DI28
SDAx, SCLx
0.7 VDD —
VDD
V SMBus disabled
DI29
SDAx, SCLx
2.1
—
VDD
V SMBus enabled
ICNPU CNx Pull-up Current
DI30
50
250 400
μA VDD = 3.3V, VPIN = VSS
Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: See “Pin Diagrams” for a list of 5V tolerant pins.
5: VIL source < (VSS – 0.3). Characterized but not tested.
6: Non-5V tolerant pins VIH source > (VDD + 0.3), 5V tolerant pins VIH source > 5.5V. Characterized but not
tested.
7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5.5V.
8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.
9: Any number and/or combination of I/O pins not excluded under IICL or IICH conditions are permitted pro-
vided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not
exceed the specified limit. Characterized but not tested.
10: These parameters are characterized, but not tested.
© 2007-2011 Microchip Technology Inc.
DS70282E-page 193