MV78200 Datasheet, PDF (70/128 Pages) –

MV78200
Hardware Specifications
9.5
DC Electrical Specifications
Note
See the Pin Description Section for internal pullup/pulldown,
9.5.1
General 3.3V (CMOS) DC Electrical Specifications
Table 33 is relevant for the following interfaces that only operate at 3.3V:
„ SPI
„ JTAG
Table 33 is also relevant if the following interfaces are configured to operate at 3.3V, according to
Section 7.2, Hardware Reset, on page 55.
„ Device Bus
„ MPP
„ RGMII
„ GMII
„ MII
„ SMI
„ TDM
„ SYSRSTn
„ UART
„ REF_CLK_PT
„ TCLK_OUT
„ TCLK_IN
Table 33: General 3.3V Interface (CMOS) DC Electrical Specifications
Param eter
Input low level
Input high level
Output low level
Output high level
Input leakage current
Pin capacitance
Sym bol Test Condition
VIL
VIH
VOL IOL = 2 mA
VOH IOH = -2 mA
IIL 0 < VIN < VDDIO
Cpin
M in
Typ
M ax
Units Notes
-0.3
0.8
V
-
2.0
VDDIO+0.3 V
-
-
0.4
V
-
2.4
-
V
-
-10
10
uA 1, 2
5
pF
-
Note s :
1. While I/O is in High-Z.
2. This current does not include the current flow ing through the pullup/pulldow n resistor.
MV-S104671-U0 Rev. C
Page 70
Document Classification: Proprietary Information
Copyright © 2008 Marvell
December 6, 2008, Preliminary