MC9S08GT16A Datasheet, PDF (57/300 Pages) Freescale Semiconductor, Inc – Microcontrollers

Table 4-7. FLASH Clock Divider Settings
f_Bus
20 MHz
10 MHz
8 MHz
4 MHz
2 MHz
1 MHz
200 kHz
150 kHz
PRDIV8
(Binary)
1
0
0
0
0
0
0
0
DIV5:DIV0
(Decimal)
12
49
39
19
9
4
0
0
f_FCLK
192.3 kHz
200 kHz
200 kHz
200 kHz
200 kHz
200 kHz
200 kHz
150 kHz
Program/Erase Timing Pulse
(5 µs Min, 6.7 µs Max)
5.2 µs
5 µs
5 µs
5 µs
5 µs
5 µs
5 µs
6.7 µs
Memory
4.6.2 FLASH Options Register (FOPT and NVOPT)
During reset, the contents of the nonvolatile location NVOPT are copied from FLASH into FOPT. Bits 5
through 2 are not used and always read 0. This register may be read at any time, but writes have no meaning
or effect. To change the value in this register, erase and reprogram the NVOPT location in FLASH memory
as usual and then issue a new MCU reset.
R
W
Reset
7
KEYEN
6
5
4
3
2
1
FNORED
0
0
0
0
SEC01
This register is loaded from nonvolatile location NVOPT during reset.
= Unimplemented or Reserved
Figure 4-6. FLASH Options Register (FOPT)
0
SEC00
Table 4-8. FOPT Field Descriptions
Field
7
KEYEN
Description
Backdoor Key Mechanism Enable — When this bit is 0, the backdoor key mechanism cannot be used to
disengage security. The backdoor key mechanism is accessible only from user (secured) firmware. BDM
commands cannot be used to write key comparison values that would unlock the backdoor key. For more detailed
information about the backdoor key mechanism, refer to Section 4.5, “Security.”
0 No backdoor key access allowed.
1 If user firmware writes an 8-byte value that matches the nonvolatile backdoor key (NVBACKKEY through
NVBACKKEY+7, in that order), security is temporarily disengaged until the next MCU reset.
MC9S08GT16A/GT8A Data Sheet, Rev. 1
Freescale Semiconductor
57