MC9S08GT16A Datasheet, PDF (267/300 Pages) Freescale Semiconductor, Inc – Microcontrollers

Electrical Characteristics
Table A-7. Supply Current Characteristics (continued)
Parameter
Symbol V_DD (V)
Typical¹
Max²
Temp. (°C)
Stop3 mode supply current
3
S3I
DD
2
675 nA
500 nA
4.3 µA⁽⁴⁾
55
7.2 µA⁽⁴⁾
70
17.0 µA⁽⁵⁾
85
45 µA⁽⁵⁾
125
3.5 µA⁽⁴⁾
55
6.2 µA⁽⁴⁾
70
15.0 µA⁽⁴⁾
85
40 µA⁽⁴⁾
125
RTI adder to stop2 or stop3⁶
3
300 nA
2
300 nA
LVI adder to stop3
(LVDSE = LVDE = 1)
3
70 µA
2
60 µA
Adder to stop3 for oscillator enabled⁷
(OSCSTEN =1)
3
5 µA
2
5 µA
Adder for loss-of-clock enabled
(LOCD=0)
3
9 µA
2
9 µA
Adder for high gain oscillator enabled
(HGO=1)
3
28 µA
2
2 µA
1 _{Typicals are measured at 25°C. See Table A-6 through Table A-9 for typical curves across voltage/temperature.}
2 _{Values given here are preliminary estimates prior to completing characterization.}
3 _{All modules except ATD active, ICG configured for FBE, and does not include any dc loads on port pins}
4 _{Values are characterized but not tested on every part.}
5 _{Every unit tested to this parameter. All other values in the Max column are guaranteed by characterization.}
6 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait mode.}
Wait mode typical is 560 µA at 3 V and 422 µA at 2V with f_Bus = 1 MHz.
7 _{Values given under the following conditions: low range operation (RANGE = 0), low power mode (HGO = 0), clock monitor}
disabled (LOCD = 1).
MC9S08GT16A/GT8A Data Sheet, Rev. 1
Freescale Semiconductor
267