English
Language : 

XC3S200A-4VQG100C Datasheet, PDF (61/132 Pages) Xilinx, Inc – Architectural and Configuration Overview
DC and Switching Characteristics
Byte Peripheral Interface (BPI) Configuration Timing
PROG_B
(Input)
PUDC_B
(Input)
M[2:0]
(Input)
INIT_B
Open-Drain)
LDC[2:0]
PUDC_B must be stable before INIT_B goes High and constant throughout the configuration process.
TMINIT
<0:1:0>
TINITM
Mode input pins M[2:0] are sampled when INIT_B goes High. After this point,
input values do not matter until DONE goes High, at which point the mode pins
become user-I/O pins.
Pin initially pulled High by internal pull-up resistor if PUDC_B input is Low.
Pin initially high-impedance (Hi-Z) if PUDC_B input is High.
HDC
CSO_B
New ConfigRate active
CCLK
A[25:0]
D[7:0]
(Input)
TCCLK1
T INITADDR
000_0000
Byte 0
000_0001
Byte 1
TCCLK1
TCCLKn
TAVQV
Data
TCCO
Address
Address Address
TDCC
Data
Data
TCCD
Data
Shaded values indicate specifications on attached parallel NOR Flash PROM.
Figure 15: Waveforms for Byte-wide Peripheral Interface (BPI) Configuration
DS529-3_05_021009
Table 54: Timing for Byte-wide Peripheral Interface (BPI) Configuration Mode
Symbol
Description
TCCLK1
TCCLKn
TMINIT
TINITM
TINITADDR
Initial CCLK clock period
CCLK clock period after FPGA loads ConfigRate setting
Setup time on M[2:0] mode pins before the rising edge of INIT_B
Hold time on M[2:0] mode pins after the rising edge of INIT_B
Minimum period of initial A[25:0] address cycle; LDC[2:0] and HDC are asserted
and valid
TCCO
TDCC
TCCD
Address A[25:0] outputs valid after CCLK falling edge
Setup time on D[7:0] data inputs before CCLK rising edge
Hold time on D[7:0] data inputs after CCLK rising edge
Minimum Maximum Units
See Table 46
See Table 46
50
–
ns
0
–
ns
5
5
TCCLK1
cycles
See Table 50
See TSMDCC in Table 51
0
–
ns
DS529-3 (v2.0) August 19, 2010
www.xilinx.com
61