W25N01GVZEIT-TR Datasheet, PDF (42/68 Pages) Winbond – 3V 1G-BIT SERIAL SLC NAND FLASH MEMORY WITH DUAL/QUAD SPI BUFFER READ & CONTINUOUS READ

W25N01GVxxIG/IT
8.2.17 Fast Read with 4-Byte Address (0Ch)
The Fast Read instruction allows one or more data bytes to be sequentially read from the Data Buffer after
executing the Read Page Data instruction. The Fast Read instruction is initiated by driving the /CS pin low
and then shifting the instruction code “0Ch” followed by the 16-bit Column Address and 24-bit dummy clocks
(when BUF=1) or a 40-bit dummy clocks (when BUF=0) into the DI pin. After the address is received, the
data byte of the addressed Data Buffer location will be shifted out on the DO pin at the falling edge of CLK
with most significant bit (MSB) first. The address is automatically incremented to the next higher address
after each byte of data is shifted out allowing for a continuous stream of data. The instruction is completed
by driving /CS high.
The Fast Read instruction sequence is shown in Figure 21a & 21b. When BUF=1, the device is in the Buffer
Read Mode. The data output sequence will start from the Data Buffer location specified by the 16-bit Column
Address and continue to the end of the Data Buffer. Once the last byte of data is output, the output pin will
become Hi-Z state. When BUF=0, the device is in the Continuous Read Mode, the data output sequence
will start from the first byte of the Data Buffer and increment to the next higher address. When the end of
the Data Buffer is reached, the data of the first byte of next memory page will be following and continues
through the entire memory array. This allows using a single Read instruction to read out the entire memory
array and is also compatible to Winbond’s SpiFlash NOR flash memory command sequence.
Figure 21a. Fast Read with 4-Byte Address Instruction (Buffer Read Mode, BUF=1)
Figure 21b. Fast Read with 4-Byte Address Instruction (Continuous Read Mode, BUF=0)
- 41 -