W25N01GVZEIT-TR Datasheet, PDF (14/68 Pages) Winbond – 3V 1G-BIT SERIAL SLC NAND FLASH MEMORY WITH DUAL/QUAD SPI BUFFER READ & CONTINUOUS READ

W25N01GVxxIG/IT
code directly from the SPI bus (XIP). When using Dual SPI instructions, the DI and DO pins become
bidirectional I/O pins: IO0 and IO1.
6.1.3 Quad SPI Instructions
The W25N01GV supports Quad SPI operation when using instructions such as “Fast Read Quad Output
(6Bh)”, “Fast Read Quad I/O (EBh)” and “Quad Program Data Load (32h/34h)”. These instructions allow
data to be transferred to or from the device four to six times the rate of ordinary Serial Flash. The Quad
Read instructions offer a significant improvement in continuous and random access transfer rates allowing
fast code-shadowing to RAM or execution directly from the SPI bus (XIP). When using Quad SPI
instructions the DI and DO pins become bidirectional IO0 and IO1, and the /WP and /HOLD pins become
IO2 and IO3 respectively.
6.1.4 Hold Function
For Standard SPI and Dual SPI operations, the /HOLD signal allows the W25N01GV operation to be paused
while it is actively selected (when /CS is low). The /HOLD function may be useful in cases where the SPI
data and clock signals are shared with other devices. For example, consider if the page buffer was only
partially written when a priority interrupt requires use of the SPI bus. In this case the /HOLD function can
save the state of the instruction and the data in the buffer so programming can resume where it left off once
the bus is available again. The /HOLD function is only available for standard SPI and Dual SPI operation,
not during Quad SPI. When a Quad SPI command is issued, /HOLD pin will act as a dedicated IO pin (IO3).
To initiate a /HOLD condition, the device must be selected with /CS low. A /HOLD condition will activate on
the falling edge of the /HOLD signal if the CLK signal is already low. If the CLK is not already low the /HOLD
condition will activate after the next falling edge of CLK. The /HOLD condition will terminate on the rising
edge of the /HOLD signal if the CLK signal is already low. If the CLK is not already low the /HOLD condition
will terminate after the next falling edge of CLK. During a /HOLD condition, the Serial Data Output (DO) is
high impedance, and Serial Data Input (DI) and Serial Clock (CLK) are ignored. The Chip Select (/CS)
signal should be kept active (low) for the full duration of the /HOLD operation to avoid resetting the internal
logic state of the device.
- 13 -