W83977ATF Datasheet, PDF (195/207 Pages) Winbond – WINBOND I/O

W83977ATF
PRELIMINARY
5.3.2 Data and ecpAFifo Port
Modes 000 (SPP) and 001 (PS/2) (Data Port)
During a write operation, the Data Register latches the contents of the data bus on the rising edge of
the input. The contents of this register are output to the PD0-PD7 ports. During a read operation,
ports PD0-PD7 are read and output to the host. The bit definitions are as follows:
7 6543 21 0
PD0
PD1
PD2
PD3
PD4
PD5
PD6
PD7
Mode 011 (ECP FIFO-Address/RLE)
A data byte written to this address is placed in the FIFO and tagged as an ECP Address/RLE. The
hardware at the ECP port transmits this byte to the peripheral automatically. The operation of this
register is defined only for the forward direction. The bit definitions are as follows:
7 6 5 4 32 1 0
Address or RLE
Address/RLE
5.3.3 Device Status Register (DSR)
These bits are at low level during a read of the Printer Status Register. The bits of this status register
are defined as follows:
7 65 43 2 1 0
11 1
nFault
Select
PError
nAck
nBusy
- 91 -
Publication Release Date:April 1998
Revision 0.52