W83977ATF Datasheet, PDF (137/207 Pages) Winbond – WINBOND I/O

W83977ATF
PRELIMINARY
Bit 6: INTVERTZ
This bit determines the polarity of all FDD interface signals.
= 0 FDD interface signals are active low.
= 1 FDD interface signals are active high.
Bit 5: DRV2EN (PS2 mode only)
When this bit is a logic 0, indicates a second drive is installed and is reflected in status register A.
Bit 4: Swap Drive 0, 1 Mode
= 0 No Swap (Default)
= 1 Drive and Motor sel 0 and 1 are swapped.
Bit 3 - 2 Interface Mode
= 11 AT Mode (Default)
= 10 (Reserved)
= 01 PS/2
= 00 Model 30
Bit 1: FDC DMA Mode
= 0 Burst Mode is enabled
= 1 Non-Burst Mode (Default)
Bit 0: Floppy Mode
= 0 Normal Floppy Mode (Default)
= 1 Enhanced 3-mode FDD
CRF1 (Default 0x00)
Bit 7 - 6: Boot Floppy
= 00 FDD A
= 01 FDD B
= 10 FDD C
= 11 FDD D
Bit 5, 4: Media ID1, Media ID0. These bits will be reflected on FDC's Tape Drive Register bit 7, 6.
Bit 3 - 2: Density Select
= 00 Normal (Default)
= 01 Normal
= 10 1 ( Forced to logic 1)
= 11 0 ( Forced to logic 0)
Bit 1: DISFDDWR
= 0 Enable FDD write.
= 1 Disable FDD write(forces pins WE, WD stay high).
Bit 0: SWWP
= 0 Normal, use WP to determine whether the FDD is write protected or not.
= 1 FDD is always write-protected.
-138 -
Publication Release Date: Auguest 1997
Revision 0.51