W83977ATF Datasheet, PDF (147/207 Pages) Winbond – WINBOND I/O

W83977ATF
PRELIMINARY
Bit 2: Reserved.
Bit 1: Polarity: 1: Invert, 0: No Invert
Bit 0: In/Out: 1: Input, 0: Output
CRE7 (GP17, Default 0x01)
Bit 7 - 4: Reserved.
Bit 4 - 3: Select Function.
= 00 Select Basic I/O function.
= 01 Select 1st alternate function: Power LED output. Please refer to TABLE C
= 1x Reserved
Bit 2: Reserved.
Bit 1: Polarity: 1: Invert, 0: No Invert
Bit 0: In/Out: 1: Input, 0: Output
TABLE C
WDT_CTRL1* BIT[1]* WDT_CTRL0* BIT[3] WDT_CTRL1 BIT[0] POWER LED STATE
1
X
X
1 Hertz Toggle pulse
0
0
X
Continuous high or low*
0
1
0
Continuous high or low*
0
1
1
1 Hertz Toggle pulse
*Note: 1). Regarding to the contents of WDT_CTR1 and WDT_CTRL0, please refer to CRF3 and CRF4 in Logic Device 8.
2). Continuous high or low depends on the polarity bit of GP13 or GP17 configure registers.
CRF1 ( Default 0x00)
General Purpose Read/Write Enable*
Bit 7 - 2: Reserved
Bit 1:
= 1 Enable General Purpose Write Strobe
= 0 Disable General Purpose Write Strobe
Bit 0:
= 1 Enable General Purpose Address Decode
= 0 Disable General Purpose Address Decode
*Note: If the logical device's activate bit is not set then bit 0 and 1 have no effect.
- 147 -
Publication Release Date:April 1998
Revision 0.52