UPSD3212A Datasheet, PDF (79/163 Pages) STMicroelectronics – Flash Programmable System Devices with 8032 MCU with USB and Programmable Logic

uPSD3212A, uPSD3212C, uPSD3212CV
Table 66. USB Endpoint0 Transmit Control Register (UCON0: 0EAh)
7
6
5
4
3
2
TSEQ0
STALL0
TX0E
RX0E
TP0SIZ3
TP0SIZ2
1
TP0SIZ1
0
TP0SIZ0
Table 67. Description of the UCON0 Bits
Bit
Symbol
R/W
Function
Endpoint0 Data Sequence Bit. (0=DATA0, 1=DATA1)
7
TSEQ0
R/W
This bit determines which type of data packet (DATA0 or DATA1) will be
sent during the next IN transaction. Toggling of this bit must be controlled
by software. RESET clears this bit
Endpoint0 Force Stall Bit.
This bit causes Endpoint 0 to return a STALL handshake when polled by
6
STALL0
R/W
either an IN or OUT token by the USB Host Controller. The USB
hardware clears this bit when a SETUP token is received. RESET clears
this bit.
Endpoint0 Transmit Enable.
This bit enables a transmit to occur when the USB Host Controller sends
an IN token to Endpoint 0. Software should set this bit when data is ready
5
TX0E
R/W
to be transmitted. It must be cleared by software when no more Endpoint
0 data needs to be transmitted. If this bit is '0' or the TXD0F is set, the
USB will respond with a NAK handshake to any Endpoint 0 IN tokens.
RESET clears this bit.
Endpoint0 receive enable.
This bit enables a receive to occur when the USB Host Controller sends
4
RX0E
R/W
an OUT token to Endpoint 0. Software should set this bit when data is
ready to be received. It must be cleared by software when data cannot be
received. If this bit is '0' or the RXD0F is set, the USB will respond with a
NAK handshake to any Endpoint 0 OUT tokens. RESET clears this bit.
3 to 0
TP0SIZ3 to
TP0SIZ0
R/W
The number of transmit data bytes. These bits are cleared by RESET.
79/163