UPSD3212A Datasheet, PDF (1/163 Pages) STMicroelectronics – Flash Programmable System Devices with 8032 MCU with USB and Programmable Logic

uPSD3212A, uPSD3212C
uPSD3212CV
Flash Programmable System Devices with
8032 MCU with USB and Programmable Logic
FEATURES SUMMARY
■ FAST 8-BIT 8032 MCU
– 40MHz at 5.0V, 24MHz at 3.3V
– Core, 12-clocks per instruction
■ DUAL FLASH MEMORIES WITH MEMORY
MANAGEMENT
– Place either memory into 8032 program
address space or data address space
– READ-while-WRITE operation for In-
Application Programming and EEPROM
emulation
– Single voltage program and erase
– 100K minimum erase cycles, 15-year
retention
■ CLOCK, RESET, AND SUPPLY
MANAGEMENT
– SRAM is Battery Backup capable
– Normal, Idle, and Power Down Modes
– Power-on and Low Voltage reset
supervisor
– Programmable Watchdog Timer
■ PROGRAMMABLE LOGIC, GENERAL
PURPOSE
– 16 macrocells
– Implements state machines, glue-logic,
and so forth
■ COMMUNICATION INTERFACES
– I²C Master/Slave bus controller
– Two UARTs with independent baud rate
– Six I/O ports with up to 46 I/O pins
– 8032 Address/Data bus available on
TQFP80 package
– 5 PWM outputs, 8-bit resolution
– USB v1.1, low-speed 1.5Mbps, 3
endpoints (uPSD3212A only)
Figure 1. Packages
TQFP52 (T)
52-lead, Thin,
Quad, Flat
TQFP80 (U)
80-lead, Thin,
Quad, Flat
■ JTAG IN-SYSTEM PROGRAMMING
– Program the entire device in as little as
10 seconds
■ A/D CONVERTER
– Four channels, 8-bit resolution, 10µs
■ TIMERS AND INTERRUPTS
– Three 8032 standard 16-bit timers
– 10 Interrupt sources with two external
interrupt pins
■ Single Supply Voltage
– 4.5 to 5.5V
– 3.0 to 3.6V
December 2004
1/163