UPSD3212A Datasheet, PDF (108/163 Pages) STMicroelectronics – Flash Programmable System Devices with 8032 MCU with USB and Programmable Logic

uPSD3212A, uPSD3212C, uPSD3212CV
Decode PLD (DPLD)
The DPLD, shown in Figure 55, is used for decod-
ing the address for PSD MODULE and external
components. The DPLD can be used to generate
the following decode signals:
– 4 Sector Select (FS0-FS3) signals for the
primary Flash memory (three product terms
each)
– 2 Sector Select (CSBOOT0-CSBOOT1)
signals for the secondary Flash memory (three
product terms each)
– 1 internal SRAM Select (RS0) signal (two
product terms)
– 1 internal CSIOP Select signal (selects the
PSD MODULE registers)
– 2 internal Peripheral Select signals
(Peripheral I/O Mode).
Figure 55. DPLD Logic Array
3
CSBOOT 0
3
CSBOOT 1
I /O PORTS (PORT A,B,C)1
(INPUTS)
(20)
MCELLAB.FB [7:0] (FEEDBACKS) ⁽⁸⁾
MCELLBC.FB [7:0] (FEEDBACKS) (8)
PGR0 - PGR7
(8)
A[15:0]2
(16)
PD[2:1]
(2)
PDN (APD OUTPUT)
(1)
PSEN, RD, WR, ALE2
(4)
RESET ²
(1)
RD_BSY
(1)
Note: 1. Port A inputs are not available in the 52-pin package
2. Inputs from the MCU module
3
FS0
3
FS1 4 PRIMARY FLASH
MEMORY SECTOR
3
FS2 ^SELECTS
3
FS3
2
RS0
SRAM SELECT
1
CSIOP
I/O DECODER
SELECT
1
PSEL0
PERIPHERAL I/O
1
PSEL1
MODE SELECT
AI07436
108/163