LAN9115_05 Datasheet, PDF (44/131 Pages) SMSC Corporation – Highly Efficient Single- Chip 10/100 Non-PCI Ethernet Controller

Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
■ Set EXT_PHY_SEL described in Section 5.3.9, "HW_CFG—Hardware Configuration Register" to
the desired MII port. This step switches the RXD[3:0], RX_DV, RX_ER, TXD[3:0], TX_EN, CRS
and COL signals to the desired port.
■ Set PHY_CLK_SEL described in Section 5.3.9, "HW_CFG—Hardware Configuration Register" to
the desired port. This must be the same port that is selected by EXT_PHY_SEL.
■ The host must wait a period of time of not less than 5 cycles of the slowest, newly enabled clock
before executing the next step in this procedure.
■ Enable theLAN9115 transmitter.
■ Enable the LAN9115 receiver.
The process is complete. The LAN9115 is now operational using the newly selected MII device.
The above procedure must be repeated each time the MII port is switched. The procedure is identical
when switching from internal PHY to external MII, or vice-versa.
Revision 1.1 (05-17-05)
44
DATASHEET
SMSC LAN9115