LAN9115_05 Datasheet, PDF (127/131 Pages) SMSC Corporation – Highly Efficient Single- Chip 10/100 Non-PCI Ethernet Controller

Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
Table 7.1 Power Consumption Device Only (continued)
MODE
TOTAL POWER - TYPICAL (MW)
D1, Idle
262
D2, Energy Detect Power Down (Cable disconnected)
35
D2, General Power Down
11
Note 7.1 Each LED indicator in use adds approximately 4 mA to the Digital power supply.
Note 7.2 D0 = Normal Operation, D1 = WOL (Wake On LAN mode), D2= Low Power Energy Detect.
7.3
Power Consumption Device and System Components
This section describes typical power consumption values of a total Ethernet LAN connectivity solution,
which includes external components supporting the SMSC Ethernet controller. The values below
should be used as comparision measurements only for power provisioning.
Please refer to application note “AN 12-5 Designing with the LAN9118 - Getting Started”, that can be
found on SMSC’s web site www.smsc.com, which details the magnetics and other components used.
Power measurements taken under the following conditions:
Temperature: .................................................................................................................................. +25° C
Device VDD:..................................................................................................................................+3.30 V
Table 7.2 Power Consumption Device and System Components
MODE
10BASE-T Operation
D0, 10BASE-T /w traffic
D0, Idle
D1, 10BASE-T /w traffic
D1, Idle
D2, Energy Detect Power Down
D2, General Power Down
100BASE-TX Operation
D0, 100BASE-TX /w traffic
D0, Idle
D1, 100BASE-T /w traffic
D1, Idle
D2, Energy Detect Power Down
D2, General Power Down
TOTAL POWER - TYPICAL (MW)
614
637
513
513
56
32
518
576
414
414
56
32
Note 7.3 Each LED indicator in use adds approximately 4 mA to the Digital power supply.
SMSC LAN9115
127
DATASHEET
Revision 1.1 (05-17-05)